CHIP CONVEYORS
6Pages

{{requestButtons}}

Catalog excerpts

CHIP CONVEYORS - 1

TraspOftatOfi \ Chip conveyors The vast experience gained in many years of collaboration with builders and users of machines for remo- ving chip allows us to offer our clients a wide range of products to make chip disposal and coolant filtration easy, cost-effective and efficient, Flexible enough to be applied the removal of extremely voluminous and tough chip as well as the removal of small and malleable chip. In the hinged-belt type chip conveyor the hinged belt with the chips fallen on it moves without coming into contact with the bottom. The water-tight electro welded metal sheet structure is very robust, thanks to a thickness of at least 30/10. If the operating conditions are particularly tough, wear-proof material is used or we adopt solutions that guarantee a longer life.

Open the catalog to page 1
CHIP CONVEYORS - 2

Trasportatori \ Chip conveyors 5PPIRE PPIRT5 FOR BELT CHIP COHVEYOR

Open the catalog to page 2
CHIP CONVEYORS - 3

TraspOftatOfi \ Chip conveyors When the chip is especially Pine, scraper conveyors can be used. In this case the scraper removes waste material Prom the bottom of the conveyor and Prom the slope and carries it to the waste outlet. Very suitable Por integrating with Piltration systems. 5CRP1PER BELT TECHNICAL DfiTPl

Open the catalog to page 3
CHIP CONVEYORS - 4

Trasportatori \ Chip conveyors FORM TO REQUEST AM ESTIMATE STRAIGHT CHIP COMVEYOR STRAIGHT COMVEYOR COMVEYOR WITHOUT TPiMK COMVEYOR WITH TFIMK CHIP COMVEYOR WITH UPWARD SLOPE IMDICPTE FLOW, PRE55URE OR PI DESCRIPTION OF REQUIREMENTS IM THE EVEMT OF IM5TPILLED PUMP " the indicated dimensions need to be filled in only if a tank is present TFIMK PUMP

Open the catalog to page 4
CHIP CONVEYORS - 5

uuiuiju.metalgennari.it Tra5pOftatori \ Chip conveyors If possible and cost-effective, Metal Qennari offers - on the basis oP a cost estimate - the overhaul service on every type oP chip conveyor at its uuorkshop. The overhaul service consists in the Pollouuing tasks: Disassembly and external mashing oP the equipment Repair oP the sheet metal structure, reconditioning oP damaged conveyor slides and guides Partial or total replacement oP the belt IP necessary, replacement oP the drive and/or idle pinion gears, drive and/or idle shaPts, Repainting is available only upon request The chip...

Open the catalog to page 5
CHIP CONVEYORS - 6

Trasportabori \ Chip conveyors Pis an alternative to scraper chip conveyors, we recommend screw conveyors when a small conveyor is needed to remove very small chip or even dust. The chip is transported by means of a rotating coil built from a flat bar inside a tapered casing built over the coil. In special conditions it is possible to preset the end to discharge chip 500/600 mm from bhe edge of In the presence of abrasive materials the sliding and the coil can be supplied in anti-wear material. 5CREW CHIP CONVEYOR WITH CORE 5CREW CHIP CONVEYOR WITHOUT CORE COIL PROFILE COIL PROFILE

Open the catalog to page 6

All Metal Gennari S.R.L. catalogs and technical brochures

  1. HOUSINGS

    10 Pages

  2. GENERAL

    45 Pages

  3. Fairings

    10 Pages

  4. Conveyors

    6 Pages