MEMOFOOD HIGH-PERFORMANCE FOOD GRADE GREASE DESCRIPTION MEMOFOOD is grease for high loads and long-lasting lubrication under difficult environmental conditions. It is formulated with medicinal white oil base and synthetic hydrocarbons, reinforced with additives and solid lubricants to improve its performance. A complex soap thickening agent is used, which is highly resistant to temperatures. It is a lubricant suitable for incidental contact with food, classified as H1 by the NSF. Especially indicated for lubricating open or closed points under tough working conditions: exposure to environmental humidity, vibration, steam, dirt, high loads and pressures. Thanks to its properties, the lubrication periods can be extended. For plain and ball bearings that work at medium speeds under difficult environmental conditions up to a speed factor of approximately 500,000 (speed factor: average bearing diameter in mm X the rotation speed in R.P.M.). Especially appropriate for application at bottling plants, food packaging plants (cappers in the canned food industry and vegetable-fruit warehouses), pelleting machines, purification plants, etc. Excellent adherence and sealing capacity, which allows the lubrication intervals to be extended, even in the presence of cold or hot water, salt water and steam. Protects against corrosion. Working temperature from –20º to +130º C. It can withstand temperature peaks of 150º C. High resistance to ageing and to shearing. High capacity to withstand loads and extreme pressure. Good behaviour in central lubrication systems Technical data sheet. Revision : 28/10/2014. These technical descriptions correspond to our present technical knowledge. The data above- mentioned are determined average values. Derivations within the usual tolerances can take place. MEMOLUB INTERNATIONAL S.A. Rue Bollinckx 43 B-1070 Brussels [email protected] 2014-10-29

MEMOFOOD APPLICATION NOTES Hand pump, air pump Autonomous lubricators MEMOLUB® refills 120, 240 and 480 cc Sealed bearings must be filled to a maximum of half their capacity To the extent possible, avoid mixing with other types of grease When a replacement product, on grease and hunt up the old grease. Be careful not to pollute the grease during its application by dust or other pollutants. TECHNICAL DATA Units Typical values Dropping point Consistency NLGI Four ball wear test 400N, 75ºC, 1 hour Welding load – Four ball test Bearing corrosion Technical data sheet. Revision : 28/10/2014. These...