Catalogs >
Endevco >
43A

43A
3Pages

Catalog excerpts

Isotron® accelerometer -UNIT IDENTIFICATION THIS SURFACE \ MATES WITH ENDEVCO • General purpose single axis Isotron® accelerometer • Wide frequency bandwidth • Hermetically sealed • Signal ground isolated from mounting surface • IEEE P1451.4 TEDS capable STANDARD TOLERANCE INCHES [MILLIMETERSJ Model 43A is a cost effective general purpose Isotron® accelerometer designed for use in a variety of applications. 43A is a small Isotron accelerometer with a unique cube shape, allowing the sensor to be mounted in two different orientations. The unit is hermetically sealed against environmental 43A features an annular shear ceramic crystal which exhibits excellent output stability over time. The accelerometer incorporates an internal hybrid circuit with TEDS in a two-wire IEPE system which transmits its low impedance voltage output through the same cable that supplies the constant current power. Signal ground is electrically isolated from the outer case of the unit. Polarity inversion protection for the hybrid circuit is inherent in the circuit design. 43A is available in three sensitivities designated by a two digit suffix. The 43A16 has a sensitivity of 100 mV/g, the 43A18 and 43A19 have sensitivities of 500 mV/g and 1,000 mV/g respectively. The customer may select the mounting stud size included standard with the unit. The available stud sizes are 10-32, 1/4-28, M5 and M6. The stud size is designated following a dash after the model number. This product is fully compliant to the European Union's Low Voltage Directive, 2006/95/EC and EMC Directive 2004/108/EC and is Meggitt Sensing Systems Our measurement product competencies: Piezoelectric accelerometers I Piezoresistive accelerometers I Isotron accelerometerE I Variable capacitance accelerometers I Pressure transducers Acoustic sensors I Electronic instruments I Calibration systems I Shakers I Modal hammers I Cable assemblies

Open the catalog to page 1

Isotron® accelerometer The following performance specifications conform to ISA-RP-37.2 and are typical values, referenced at +75°F (+24°C), U mA, and 100 Hz, unless otherwise noted. Calibration data, traceable to National Institute of Standards and Technology [NIST], is supplied. Dynamic characteristics -requency response Resonance frequency Amplitude response Dhase response Sensitivity deviation over temperature Transverse sensitivity Amplitude linearity Electrical characteristics Output polarity DC output bias voltaqe Noise floor Croundmq methoc Dower requirements Digital communication...

Open the catalog to page 2

Aerospace Energy Measurement Isotron® accelerometer Model 43A Contact Model number definition 43A XX -YYY Meggitt Sensing Systems 14600 Myford Road Irvine CA 92606, USA Tel: +1 (949) 493 8181 Fax: +1 (949) 661 7231 Mounting stud option No dash number = No stud included - 1032 = 10-32 stud - 2528 = 1/4-28 stud - M5 = M5 stud - M6 = M6 stud www.endevco.com www.meggitt.com Denotes nominal sensitivity: 16 = 100 mV/g 18 = 500 mV/g 19 = 1000 mV/g Basic model number Accessories Product Optional Included Mounting stud 10-32 to 1/4-28 Optional Optional Optional Optional Optional Optional Optional...

Open the catalog to page 3