Hand Joystick Series TRY54 ■ Heavy-Duty Joystick with CAN J1939-71 or CANopen interface ■ SIL 2 compatible - redundant hall sensors ■ Shallow mounting depth < 60 mm ■ 10 million cycles resisting high axial load (up to 1780 N) ■ Multifunction handle providing space for additional functional elements (pushbutton switches, rockers, thumb joysticks, thumbwheels, etc.) Joystick of the TRY54 series were developed focussing on highly demanding heavy-duty and off-road applications. Use of metal components and optimized dimensioning of the mechanism and control lever result in an individually configurable joystick with the reliability of larger models and significantly reduced dimensions. Electrical Data Joystick Sensor Redundant Hall Sensors Output signal SAE CAN J1939-71 or CANopen Notes: 1. All values are nominal 2. Exact specifications may be subject to configuration MEGATRON Elektronik GmbH & Co. KG ■ Hermann-Oberth-Strasse 7 ■ 85640 Putzbrunn / Munich Tel.: +49 89 46094-0 ■ Fax: +49 89 46094-201 ■ www.megatron.de ■ [email protected] Specifications are subject to change without notice

Data Sheet for JoysticksHand JoystickPushbuttons Characteristics Max. Current / Voltage Rating with Resistive Load Low Level Electrical Life at Full Load Mechanical Life Environmental Seal Action Operating Force Total Travel Pushbutton Colors available 3 A 28 VDC 1 GOhm min. at 500 VDC 25000 cycles 1 million cycles IP67IEC60529 Momentary, normally-open 7 N ±3 N 1.7 mm ±0.3 mm White, Grey, Black, Red, Orange, Yellow, Green, Blue Notes: 1. If unspecified, the pushbutton caps will be colored red 2. Many other combinations of functional elements can be integrated into the faceplate, in addition to...

Hand Joystick Series TRY54 Please contact us for information regarding stock articles, delivery times and minimum order quantities. Order Code Description (1) Torque at 50% deflection (±10°) from center (2) „guided feel“ allows for omnidirectional deflection (as for standard square limiter), but in diagonal direction the required force is higher than in only x and y direction. This way, the user is guided during operation to find the main axes only direction. For higher quantities or on-going demand, additional options are available Please contact us. Because of the broad configuration options,...

Data Sheet for Joysticks Hand Joystick Technical Drawing Trigger Deadman Paddle Strain relief Dimensions in mm (inches) Panel Cut-Out MEGATRON Elektronik GmbH & Co. KG ▪ Hermann-Oberth-Strasse 7 ▪ 85640 Putzbrunn / Munich Tel.: +49 89 46094-0 ▪ Fax: +49 89 46094-201 ▪ www.megatron.de ▪ [email protected] Specifications are subject to change without notice Date: Page:

Hand Joystick Series TRY54 Connection to Deutsch-Stecker DTM04-6P PIN WIRE COLOR FUNCTION 2 GREEN CAN high data 3 BLUE Source Address SEL 1 4 ORANGE Source Address SEL 0 Standard cable length ca. 150 ±1.3 mm; wire AWG 22, PTFE Insulation. Individual cable configuration available upon request. CAN J1939 Interface Parameters* All axis and button data are delivered on a CAN 2.0B compliant physical interface. Two additional signals allow configuration of the controller Source Address. Controller messages are delivered per the SAE J1939-71 message protocol. Baud Rate 250 kHz Transmission repetition...

LENGTH FUNCTION (BITS) 2 Primary X-axis neutral position status 2 Primary X-axis left position status 2 Primary X-axis right position status 10 Primary X-axis position data 2 Primary Y-axis neutral position status 2 Primary Y-axis down position status 2 Primary Y-axis up position status 10 Primary Y-axis position data 2 Button 8 status (Paddle if 6 button configuration) 2 Button 7 status (Trigger if 6 button configuration) LENGTH FUNCTION (BITS) 2 Redundant X-axis neutral position status 2 Redundant X-axis left position status 2 Redundant X-axis right position status 10 Redundant X-axis position...