ALI 3 Permanent magnet DC motor 12-24 V Three phase or single phase AC motor Worm gearbox Acme lead screw or ballscrew (VRS) Chrome plated steel push rod Life long grease lubricated IP55 AC IP65 DC, tested according to rule CEI EN 60529 NB: Only for brake motors Standard IP54, IP65 on request Working temperature range -10°C +60°C Intermittent duty S3 30% (5 min) a +30°C, only for AC Limit switches on request Potentiometer on request Encoder on request Version At-Ex II 3 D T4 (AC motor) on request With single-phase motors type M (see motor choice guideline in paragraph ACCESSORIES) performances are 20% lower than the three-phase motor. For the DC models its is possible to add an IP20 break. * When speed is more than 30 mm/s and/or strokes longer than 350mm, check STROKE SETUP section. ** For 12 Vdc power supply currents are doubled and loads are 20% lower. ^ The brakemotor is strongly recomended BEFORE OPERATING ACTUATOR MAKE SURE YOU READ AND UNDERSTOOD BASIC OPERATIONAL INSTRUCTIONS SHOWN ON USERMANUALS, AVAILABLE FROM WEBSITE. THIS DOCUMENT DISPLAYS MOST TYPICAL STANDARD FEATURES AND SETUPS: CONTACT OUR OFFICES FOR MORE. ACTUATOR SHALL NOT COME TO MECHANICAL STROKE-END, TO AVOID FAILURES. CONSIDER MECVEL's LIMITSWITCHES ( MODEL ALI3-F or ALI3-FCM) OR PUT THEM ON MACHINE/FRAME. A MecVel reserves the right to change products information and/or features without notice; all data contained in this catalogue are purely indicative and not binding for the company.
Open the catalog to page 1VERSION WITHOUT LIMITSWITCHES AC MOTOR DIMENSIONS VERSION WITH LIMITSWITCHES AC MOTOR DIMENSIONS MecVel - Edizione 2023 MecVel - Edition 2023
Open the catalog to page 2STROKE SETUP MOTOR POSITION E-BOX POSITION LIMIT-SWITCH POSITION Useful tips for handling stroke and avoid run-on-block collision. • When stroke is more than 350 mm, add 50 mm extra-stroke as guidance, and put corresponding value in ordering-key. • WARNING SPEED-TIMING ALONG STROKELENGHT: ramps are extremely important when speed is >30 mm/s! Inverter or PWM drive recommended! • The more speed raises the more extra stroke has to raise too. Total stroke,to be stated in ordering-key Available workout stroke FULL SPEED SLOW DOWN STROKE BUCKLING When stroke is longer than 500mm, BUCKLING can be a...
Open the catalog to page 3AC: version, voltage, type, size, n°pole, power CC: version, voltage, size, Rpm With DC motor, dont consider the following lines Protection Degree: IP65, for selfbrake motor IP54 standard Brake type: for brakemotors only (es. FECA) Options: Advise if needed (es. AB 2'shaft) MOTOR POSITION - M0 None: Leave blank E-BOX POSITION Options pg.76 None: Leave blank LIMIT SWITCHES - 2FC1 None: Leave blank LIMIT SWITCHES POSITION - FC1 None: Leave blank P1 = Eyelet (standard) P2 = Eyelet (90°) A1 = Eyelet (standard) A4 = Rod end A3 = Yoke + Clip A7 = M10 male NOTE: COMPLETE THE ORDERING KEY ADDING THE...
Open the catalog to page 436 Pages
6 Pages
4 Pages
3 Pages
5 Pages
75 Pages
6 Pages
6 Pages
3 Pages
2 Pages
2 Pages
2 Pages