Slim Type with PFC Switching Power Supply User’s Manual series Video Bauar t gepruft Sicherheit egel ma ge od o s be wac g www. tuv.com ID 2000000000   ■  ‧ ‧ ‧ ‧ ‧ ‧  ‧ ‧ ‧ ‧ ‧ ■  ‧Industrial automation machinery ‧Industrial control system ‧Mechanical and electrical equipment ‧Electronic instruments, equipments or apparatus ‧Household appliances ‧LED display application

Slim Type with PFC Switching Power Supply SPECIFICATION MODEL LSP-160 DC VOLTAGE RATED CURRENT Note.7 RATED POWER (convection) Note.7 LINE REGULATION LOAD REGULATION SETUP, RISE TIME HOLD UP TIME (Typ.) VOLTAGE RANGE RIPPLE & NOISE (max.) Note.2 200mVp-p OUTPUT FREQUENCY RANGE LEAKAGE CURRENT SHORT CIRCUIT Hiccup protection,recovers automatically after fault condition is removed 130~150%rated output power(based on 160W) OVER LOAD PROTECTION Shut down O/P voltage, re-power on to recover after temperature goes down Please refer to the Function Manual Contact rating(max.):15Vdc/10mA resistive load...

Slim Type with PFC Switching Power Supply Block Diagram POWER SWITCHING RECTIFIERS & FILTER DETECTION CIRCUIT LOAD SHARING RATED CURRENT (%) RATED CURRENT (%) AMBIENT TEMPERATURE WITHOUT ALUMINUM PLATE(℃) STATIC CHARACTERISTIC RATED CURRENT (%) NOTE: Tc measurement point ,please refer page 5 mechanical specification.

Slim Type with PFC Switching Power Supply Function Manual 1.DC_OK Signal DC_OK is a collector shorted signal. It is used by an optocoupler in the power supply which indicates the output status of the power supply as exhibited below. Optocoupler Rating(max.) Power Status DC_OK signal Short circuit/OLP 2.Redundant function: LSP-160 has built-in redundant function and can be connected 2 units in parallel for current sharing. ※ Difference of output voltages among parallel units should be less than 0.2V(Can Fine tune by SVR1). ※ When in parallel operation the maximum load should not be greater than...

Slim Type with PFC Switching Power Supply Mechanical Specification CASE NO.:279 DC Output Connector(TB2/TB3)pin NO. Assignment Max mounting torque 5Kgf-cm Mating Housing ◎ CN1 and CN2 mating cable by request, please consult MEANWELL for details

Slim Type with PFC Switching Power Supply ※ W-Type(Wafer connector type optional) 194 130 185.5 DC Output Connector(+V/-V)pin NO. Assignment Mating housing Mating Housing ◎ CN1 and CN2 mating cable by request, please consult MEANWELL for details

Slim Type with PFC Switching Power Supply Installation 1.Operate with additional aluminum plate In order to meet the“Derating Curve”and the “Static Characteristics” ,LSP-160 series must be installed onto an aluminum plate(or the cabinet of the same size) on the bottom.The size of the suggested aluminum plate is shown as below. And for optimizing thermal performance, the aluminum plate must have an even and smooth surface (or coated with thermal grease), and LSP-160 series must be firmly mounted at the center of the aluminum plate.