GENERATOR CONTROLLER
2Pages

{{requestButtons}}

Catalog excerpts

GENERATOR CONTROLLER - 1

Datasheet_KSQ332EJD1 (rev 1.0... - pdfMachine from Broadgun Software, http://pdfmachine.com, a great PDF writer utility! table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:4.00pt "Arial", sans-serif; } .font1 { font:6.00pt "Arial", sans-serif; } .font2 { font:7.00pt "Arial", sans-serif; } .font3 { font:8.00pt "Arial", sans-serif; } .font4 { font:10.00pt "Arial", sans-serif; } .font5 { font:17.00pt "Arial", sans-serif; } .font6 { font:11.00pt "Arial Black", sans-serif; } Spcifications Description System Voltage: 100-120,200-240, 380-440VAC: 50 or 60Hz Aux Voltage: 12,24 or 48V DC Contact Rating: AC: DC: 100VA -250V/2A max. 50W-100V/1Amax. Adjustments: Puls rate Puls lenght Frequencytrim Load trim Inputs: Power I/P:-1/0/+10mA (kW) Synchronising I/P: -10/0/+10mA (KSQ105) Outputs: Total power : 0-5mA Surplus power: 0-5mA Temperature: -20 to +70°C Weight: 0.6kgs Front protection: IP41 Unit meets IEC60092-504 and relevant environmental and EMC tests specified in IEC60068/60092 and IEC61000/60533 respectively, to comply with Classification Societies requirements. 75mm The MCE105D provides volt free raise/lower signals to control the speed of the prime moverof a generator. The raise/lower outputs will provide a constant output until they reach 95% of their target speed and then will change to a pulsed output. These control signals are produced depending upon the operating status of the controller. For detailed information on use of this controller, refer to Megacon technical publication. The MCE105D has five operating modes: 1) Synchronising Control Monitors an analogue input from KSQ105 synchroniser. 2) Load and Frequency 3) Load only 4) Unload 5) Fixed kilowatt Maintains a frequency set within the unit and will load share with any other MCE105D within the system. Used when synchronised to the mains (infinite bus). Reduces the speed of the prime mover until zero kilowatts is detected. Controls the speed of the prime mover to match a kilowatt output relative to a value set by an external potentiometer. Generator SetkW mCQQCOn Norway - UK

Open the catalog to page 1
GENERATOR CONTROLLER - 2

Datasheet_KSQ332EJD1 (rev 1.0... - pdfMachine from Broadgun Software, http://pdfmachine.com, a great PDF writer utility! table.main {} tr.row {} td.cell {} div.block {} div.paragraph {} .font0 { font:7.00pt "Arial", sans-serif; } .font1 { font:8.00pt "Arial", sans-serif; } .font2 { font:10.00pt "Arial", sans-serif; } .font3 { font:25.00pt "Arial", sans-serif; } .font4 { font:8.60pt "Arial Black", sans-serif; } MCE105D GENERATOR CONTROLLER Connection description of the MCE1 Terminal(s) Connection Comments 1 and 3 Generator AC This is either line to line voltage or line to neutral voltage....

Open the catalog to page 2

All Meagacon AS catalogs and technical brochures

  1. MT-VA

    2 Pages

  2. MT-VF

    2 Pages

  3. MT-AW-R

    3 Pages

  4. MT-FP

    2 Pages

  5. MT-FW/R

    3 Pages

  6. MEVx Series

    1 Pages

  7. MCVBx Series

    1 Pages

  8. KCT3x Series

    1 Pages

  9. KCM165K

    3 Pages

  10. KPM465x

    3 Pages

  11. KPM26x

    4 Pages

  12. KPM163FQ

    2 Pages

  13. KPM161FQ

    2 Pages

  14. KPM 16xM

    3 Pages

  15. K P M 1 6 x

    5 Pages