Energy Division Crompton Instruments DC DIN Shunts A range of direct current shunts which provides an accurate millivolt signal, exactly proportional to the system current. They can be used to drive ammeter indicators, overload protection and control devices. These shunts enable the measurement of D.C. current in ranges from 10A to 10000A with various output options available. ST* series complies with DIN43 703 for dimensions and IEC51 (BS89) EN60051 for performance. Specifications Input Accuracy class Temperature Coefficient Overload withstand 5 second withstand Operating temperature Rating Outputs Installation For maximum heat dissipation, mount shunts in the horizontal plane. Ample ventilation should be provided. Busbars should be adequately rated, clean and level, with a thin coat of silicone grease applied to the contact surface area. Shunts are supplied with bolts, nuts and washer, these must be tightened fully. Warning Shunts are uninsulated and protection against accidental contact may be necessary in order to comply with Health & Safety regulations. Model Part Number example: ST1-10A/60MV

a1 a2 b1 b2 b3 c1 c2 e h busbar connection bolts Bolt size Nut a1 a2 b1 b2 b3 c1 c2 e h No of terminals Bolt size Nut a1 a2 b1 b2 b3 c1 c2 e h No of terminals Bolt size Nut 100mV Models 10-30A a1 a2 b1 b2 b3 c1 c2 e h No of terminals Bolt size Nut 150mV Models 10-30A a1 a2 b1 b2 b3 c1 c2 e h No of terminals Bolt size Nut While Tyco Electronics and its affiliates referenced herein have made every reasonable effort to ensure the accuracy of the information contained in this brochure, Tyco Electronics cannot assure that this information is error free. For this reason, Tyco Electronics does not make...