ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Description The KM70z force sensor is a tension/compression force sensor with compact dimensions. Two M45x3 coarse-feeding threads are provided for application of force. The protection class is IP67. Connection is made with an M12 connector. 10m assembled connecting cable is included in scope of delivery.

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de

ME-MeUsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Technical Data Force sensor Type_ Force direction Rated force Fx Force introduction Dimension 1 Sensor Fastening Dimension 2 Operating force Rated displacement Lateral force limit Material Natural frequency Height Length or Diameter Torque limit Bending moment limit Electrical Data Input resistance Tolerance input resistance Output resistance Insulation resistance Rated range of excitation voltage f Operating range of excitation voltage f Zero signal Rated output Relative linearity error 0.1 %FS...

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Environmental protection Abbreviation : RD: „Reading“; FS: „Full Scale“; 1. The exact nominal sensitivity is indicated in the test report. 2. Values in () for compression and tension fluctuating measurement values

ME-MeUsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Description positive bridge supply negative bridge supply positive bridge output negative bridge output Wire colour PIN brown 1 Compressive load: positive output signal.

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Mounting When assembling attachment parts, hold the sensor in place on the installation side / do not conduct any tensioning torque through the sensor. Attachment parts may be supported on the adjustable foot on the end faces, if preferred. The sensor is calibrated with application of force via the thread, not via the end faces. The calibration can deviate by a few percent when force is applied via the end faces.

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de accessories Description Calibration Factory calibration certificate for force to 200 kN in accordance with DIN EN ISO / IEC 17025 for test materials monitoring according Certificate kn/200/5 to DIN ISO 9001: 2008 with 5 load levels and 3 series of measurements. Measuring amplifier in desktop-housing for sensors with straingages. Serial port RS232, USB port, analogue output -5V...+5V, limiting frequency 260Hz, input sensitivity 3.5mV/V. Measuring amplifier in aluminum housing (IP54) for sensors...