ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Description The force sensor KM40 is a precision force sensor in membrane construction for the measurement of compressive forces. The force sensor is fastened to a flat surface with four screws M4. There is a spherical cap with a radius of 50 mm provided for the force transmission. The force is applied with a flat plate against the cap. The strength introduction occurs with a flat plate against the cap. The hardness of the spherical cap is HRC 54. A flattening of the spherical cap from a load of about 20kN is therefore possible. Environmental protection rating is IP 67. In contrast to the force sensors KD, KD's and LC series lateral forces from about 5% the original naming power can lead to a measurement error greater than 1%. Therefore, the force transmission must be centric. When force sensor KM40d transverse forces are also taken up by a second membrane on the underside of the force sensor. This transverse forces can be absorbed up to 25% of capacity.

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de

ME-MeUsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Technical Data Force sensor Type_ Force direction Force introduction Dimension 1 Sensor Fastening Dimension 2 Operating force Rated displacement Lateral force limit Material Natural frequency Height Length or Diameter Electrical Data Input resistance Tolerance input resistance Output resistance Tolerance output resistance Insulation resistance Rated range of excitation voltage f Operating range of excitation voltage f Zero signal Rated output Precision Accuracy class 0,5% Relative linearity...

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Abbreviation: RD: „Reading“; FS: „Full Scale“; 1) The exact nominal sensitivity is indicated in the test report;

ME-MeUsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de Pin ConfigurationSymbol Description Wire colour +Us positive bridge supply brown -Us negative bridge supply white +Ud positive bridge output green -Ud negative bridge output yellow Pressure load: positive output signal. Shield- transparent.

ME-Meßsysteme GmbH Neuendorfstr. 18a DE-16761 Hennigsdorf Mail [email protected] Web www.me-systeme.de accessories Description Calibration Factory calibration certificate for force to 20 kN in accordance with DIN EN ISO / IEC 17025 for test materials monitoring according to Certificate kn/20/5 DIN ISO 9001: 2008 with 5 load levels and 3 series of measurements. Measuring amplifier in desktop-housing for sensors with straingages. Serial port RS232, USB port, analogue output -5V...+5V, limiting frequency 260Hz, input sensitivity 3.5mV/V. Measuring amplifier in aluminum housing (IP54) for sensors...