Specification Sheet McCrometer CONNECT Wind Direction Sensor Pro10 Pro10 Wind Direction Sensor For use with the A723s4, A753, and A752 Field Monitoring Stations McCrometer CONNECT offers the Pro10 Wind Sensor as a standalone sensor, for applications where knowing wind direction, but not wind speed is needed, or as an add-on to field stations that already measure wind speed.. The PRo10 wind direction sensor has a very low starting threshold of less than 0.4m/s, and offers an accuracy of better than +/-2.5 degrees. The housing is constructed using seawater resistant anodized aluminum, to withstand even the harshest of environmental conditions. It requires very little maintenance and will remain within it’s original specifications for many years. Please consult Selection area at the bottom of the page for ordering details. Specifications Pro 10 Wind Direction Sensor Measuring Principle Measuring Element Wind vane, Aluminum Measuring Range Starting Value Output Signal Sea water resistant anodized aluminum Operating Temperature Mounting arm with mast attachment for poles with Ø of 40mm; 2 W4-grade stainless steel pipe clamps included; alternatively in bores with Ø 30mm at max. 10mm wall strength 3255 WEST STETSON AVENUE • HEMET, CALIFORNIA 92545 USA www.mccrometer.com TEL: 951-652-6811 • 800-220-2279 • FAX: 951-652-3078 Printed In The U.S.A. Lit. # 30120-95 Rev. 1.0/03-13 Copyright © 2013 McCrometer, Inc. McCrometer, McCrometer CONNECT and NanoCourier are all trademarks of McCrometer, Inc. All printed material should not be changed or altered without permission of McCrometer. Any published technical data and instructions are subject to change without notice. Contact your McCrometer CONNECT representative for current technical data and instructions.