MAYSERPolymer Electric DIY SE 1 TPE spring contact GmbH & Co. KG Polymer Electric Orlinger StraBe 1-3 89073 Ulm GERMANY Tel. +49 731 2061-0 Fax +49 731 2061-222 E-Mail: [email protected] Internet: www.mayser.com

Polymer Electric Materials list Part no. Application The complete Safety Element SE 1 TPE is inserted into a suitable rubber profile and is optimized for the rubber profiles GP 38, GP 58, GP 68 and GP88. If another rubber profile is used, it is to be ensured that the rubber profile does not exert any pressure on the contact tube in the unloaded state. If the Safety Element SE 1 TPE is used without a rubber profile, secure attachment is to be ensured. Resistances Physical resistance Subject to technical modifications. 2/4 DIY SE 1 TPE spring contact www.mayser-sicherheitstechnik.de

Chemical resistance The Safety Element is resistant against normal chemical influences such as diluted acids and alkalis as well as alcohol over an exposure period of 24 hrs. The information in the table are results of tests carried out in our laboratory to the best of our knowledge and belief. The suitability of our products for your special area of application must always be verified with your own practical tests. Explanation of symbols: + = resistant ± = partially resistant - = not resistant Note: Tests are carried out at room temperature (+23 °C). Subject to technical modifications. www.mayser-sicherheitstechnik.de...

Polymer Electric Technical data Safety Element SE 1 TPE manufactured with resistor for 2-wire technology or without resistor for 4-wire technology. Switching characteristics at vtest = 50 mm/s Switching operations > 1x 105 Test piece (rod) 0 200 mm < 30 N Switch travel Test piece (cylinder) 0 80 mm < 3.0 mm Actuation angle Test piece (cylinder) 0 80 mm < 50° Mechanical operating conditions Safety Element length (min./max.) Bend radii, minimum A / B / C / D Tensile load, cable (max.) IEC 60529: Degree of protection Operating temperature short-term Behaviour in fire as per DIN 75200 also...