MAYSERPolymer Electric DIY SE 1 TPE moulding technology GmbH & Co. KG Polymer Electric Orlinger StraBe 1-3 89073 Ulm GERMANY Tel. +49 731 2061-0 Fax +49 731 2061-222 E-Mail: [email protected] Internet: www.mayser.com

Copyright The reproduction, distribution and utilization of this document as well as the communication of its contents without express authorization is prohibited. Offenders will be held liable for the payment of damages. All rights reserved in the event of the grant of a patent, utility model or design. © Mayser Ulm 2014

MAYSER Polymer Electric Subject to technical modifications. www.mayser-sicherheitstechnik.de SE 1 TPE moulding technology 3/7

Polymer Electric Subject to technical modifications. SE 1 TPE moulding technology 4/7 www.mayser-sicherheitstechnik.de

Polymer Electric Materials list Part no. Application The complete Safety Element SE 1 TPE is inserted into a suitable rubber profile. Suitable rubber profiles are: GP 22, GP38(L), GP 39(L), GP 50(L),GP 58(L) GP 60,GP 68, GP 88, GP 120 und GP 302. If you use a different rubber profile, make sure the rubber profile, when in a state of rest does not apply any pressure on the contact tube. If you use the Safety Element SE 1 TPE without a rubber profile, make sure it is securely fixed. Resistances Physical resistance Subject to technical modifications. www.mayser-sicherheitstechnik.de SE 1 TPE moulding...

Chemical resistance The Safety Element is resistant against normal chemical influences such as diluted acids and alkalis as well as alcohol over an exposure period of 24 hrs. The values in the table are results of tests carried out in our laboratory to the best of our knowledge and belief. The suitability of our products for your specific application purpose must always be verified with your own practical tests. Explanation of symbols: + = resistant ± = limited resistance - = not resistant Note: Tests are carried out at room temperature (+23 °C). Subject to technical modifications. SE 1 TPE moulding...

Polymer Electric Technical data Safety Element SE 1 TPE manufactured with resistor for 2-wire technology or without resistor for 4-wire technology. Switching characteristics at vtest = 50 mm/s Actuating distance Test piece (cylinder) 0 80 mm < 3.0 mm Actuation angle Test piece (cylinder) 0 80 mm < 50° Mechanical operating conditions Safety element length (min./max.) Bend radii, minimum A / B / C / D Tensile load, cable EN 60529: Protection class Operating temperature short-term Behaviour in fire as per DIN 75200 also complies with min. 100 mm / max. 50 m 350 / - / - / - mm max. 30 N IP65 -25...