*mydirectindustry

Catalogs
Maxphotonics Co., Ltd
1000W Cutting Data Sheet

1000W Cutting Data Sheet

Product catalog summary

Specifications:
The document provides cutting parameters for the MFSC-1000 laser cutting machine, focusing on stainless steel and mild steel materials. It includes details such as material thickness, cutting speed, nozzle type, power percentage, focus, gas type, gas pressure, cutting height, and punching parameters.

Stainless Steel Cutting:
For stainless steel 304, the document outlines parameters for thicknesses ranging from 1mm to 4mm. Key points include using nitrogen (N2) as the cutting gas with pressures between 1.50 to 2.00 Mpa, and a single nozzle setup. The focus varies from -1.5 to -3.5, with cutting speeds decreasing as thickness increases.

Mild Steel Cutting:
Parameters for mild steel range from 1mm to 12mm thickness. Oxygen (O2) is used as the cutting gas with pressures from 0.25 to 4.75 Mpa. A double nozzle setup is recommended, with focus adjustments from 0 to 5. Cutting speeds and punching parameters are adjusted based on material thickness.

Recommendations:
For stainless steel, cutting corners may result in burrs, which can be adjusted using a power curve. For mild steel, cutting with air for 1-2mm thicknesses results in faster speeds without overburning. It is advised to optimize parameters based on actual cutting effects, as the provided parameters are for reference only.

Notes:
Thick material cutting speeds can vary by ±0.3 without significant issues. The document emphasizes the importance of adjusting parameters according to the specific cutting scenario.

Catalog excerpts

New Add: No.4, Furong Industrial Park, Third Furong Road, Xinqiao, Shajing Town, Bao'an, Shenzhen, China 518104 Mobile: +86 18816741969 Fax: +86-755-29902782 Website: http://en.maxphotonics.com/ E-mail: [email protected]

Open the catalog to page 1

Remark: Stainless steel cutting corner with burr, which can use power curve to adjust (see the picture) 1~2mm mild steel cutting by air, cutting speed is faster. And it will not happen overburnning cause by high speed & air pressure. Thick materials cutting speed between ±0.3 will be OK Note: This process parameters for reference only , please optimize parameters reasonablly according to actual cutting effe

Open the catalog to page 2

All Maxphotonics Co., Ltd catalogs and technical brochures

Archived catalogs

Maxphotonics 30W 915nm fiber coupled Semiconductor laser module
1 Page
Maxphotonics 150W 915nm fiber coupled Semiconductor laser module
1 Page

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list