MV 6902
MV 6902
- Torque and Load: Transmissible torque ranges from 164 to 8,780 Nm. Transmissible axial load is specified with Mt=0 Nm.
- Materials: Performance values are valid for stainless steel shafts and hubs. Consult MAV Technical Dept. for other materials.
- Design: Self-centering, self-locking with a fixed axial hub position during tightening. Features a single taper design and a fitting length larger than MAV 1061.
- Lubrication: Uses FDA approved food grade oil, class H-1.
- Tolerances: Shaft tolerance h8; hub bore tolerance H8. Surface finish should be between 0.8 ≤ Ra ≤ 3.2 µm.
- Slotted inner ring with integrated push-off tapped holes.
- Slotted outer ring.
- Spacer ring.
- Set of socket head cap screws, grade A4-80.
- Contact pressure on shaft (Ps) and hub bore (Ph) varies with dimensions and is specified in MPa.
- Dimensions and weights are provided for various sizes, with screw size and tightening torque (Ma) specified.
- Ensure compatibility of materials for optimal performance.
- Follow specified tolerances and surface finishes for installation.
Catalog excerpts
Features Transmissible torque from 164 to 8.780 Nm Self-centering, self-locking Fixed axial hub position during tightening Single taper design Fitting length larger than MAV 1061 Lubrication: food grade oil FDA approved class H-1 Tolerances: shaft h8; hub bore H8 Shaft and hub bore surface finish 0.8 < Ra < 3.2 pm Composition • Slotted inner ring, with integrated push-off tapped holes • Slotted outer ring • Spacer ring • Set of socket head cap screws, grade A4-80 Listed performances are valid as long as shaft and hub are made of stainless steel. Should these parts be made of different materials, listed values might not apply. Please consult MAV Technical Dept. for advise. Information subject to change without prior notification, © MAV S.p.A. Locking Assemblies
Open the catalog to page 1
