Catalogs >
Matsushita Electric Works >
Contact-type Digital Displacement Sensor Head

Contact-type Digital Displacement Sensor Head
2Pages

Catalog excerpts

Contact-type Digital Displacement Sensor Head - 1

Self-Monitoring Sensor Digital Displacement Sensor Head HG-S1050 50 mm 1.969 in type General Purpose Long stroke Newly arrived 50 mm 1.969 in type! A bending-resistant cable provides peace of mind even when the sensor head is installed on a movable tool. *3: Sensor head connection cable is sold separately. A straight connector and L-shaped connector are also available. Lightweight with a robust yet slim body! Optical absolute method eliminates “value skipping” and “unset zero point”! Plain bearings with 2-point support structure Disperses lateral shock to significantly reduce the risk of breakage. • Length: 3 m 9.843 ft • Length: 7 m 22.966 ft • Length: 10 m 32.808 ft • Length: 20 m 65.617 ft The sensor head can be replaced without turning OFF the controller power. Slender (W 17.5 × H 173.5 × D 27 mm W 0.689 × H 6.831 × D 1.063 in) and lightweight (approx. 180 g) body Realizes the industry’s smallest*1 class of sensor head. Metal guide whirl-stop structure Risk of damage and measurement failure due to deformation and wear deterioration are significantly reduced. *1: As of November 2019, in-company survey. Sensor head 50 mm 1.969 in type Spindle stopper Blocks upward thrust impact. Tip deviation amount of 40 μm 1.575 mil or less (typical value)*2 Deviation of the measurement point is held to a minimum. *2: alue calculated from the clearance of the upper and lower V plain bearings. Application Measuring the height of machined parts *4: Controllers are sold separately. • Master unit (high-performance type) • Slave unit (high-performance type) • Slave unit (standard type) • Slave unit (wire-saving type)

Open the catalog to page 1

Contact-type Digital Displacement Sensor Head - 2

The CAD data can be downloaded from our website. Sensor head Installation of mounting nut attachment Notes: 1) Where measurement conditions have not been specified precisely, the conditions used were as follows: standard type measurement probe (TR-S10-C), ambient temperature +20 °C +68 °F, and a clean atmosphere where dust and liquids such as water and oil do not come in contact with the equipment. 2) Always connect the 50 mm 1.969 in type (HG-S1050) to an HG-SC^ controller manufactured February 2019 or later. 3) Typical value near center of measurement. 4) Value calculated from the...

Open the catalog to page 2