Catalog excerpts
Miniature on-board The smallest ultra compact on-board module Low ripple, 5mVp-p(1kV output type) Wide output voltage range(Linearly variable from 0V) High performance in such a compact case External potentiometer or external control voltage programming SUMMARY TG series is miniaturized, well regulated high voltage power supply designed for PMT application. Its high reliability and low noise features are ideal for PMT or MCP applications. LINE UP Output Voltage (kVdc) 0 to 0.2 Output Minimum load () 15k MODEL Positive polar output 1 TG-0.2PTG-0.5P- : Rated output current is not to be drawn at low output voltage range. See output range below. NOTE For extra safety ground the case and 1 Specify input voltage, "5" for 5Vdc, "12" for 12Vdc, "15" for 15Vdc. 2 Specify input voltage, "12" for 12Vdc, "15" for 15Vdc. Ripple (mVp-p) Negative polar output TG-0.2N1 terminal when operation. OUTPUT RANGE SPECIFICATIONS Input voltage/current Output Current(Io) Minimum load By external potentiometer or external control voltage(Vcon-in) -5 : 0 to 2.048Vdc -12,-15 : 0 to 5Vdc Input impedance: 100k Usable range Line : ±0.001% -5 : for ±5% input voltage change -12,-15 : for ±1V input voltage change CONNECTION DIAGRAM Temperature coefficient 25ppm/°C typ. Setting voltage accuracy ±2%(at maximum output Vcon-in) Reference voltage Voltage monitor Remote ON/OFF Protection By contact signal(Open: OFF, Short: ON) Reversible input connection,(-12,-15) Intermittent output short circuit(-5,-12,-15) Temperature range Remote short:ON ON/OFF open:OFF ON/OFF Vmoni 1.Pin 2 and 8 are internally connected(isolated from CASE) 2.CASE PIN should be always connected to ground. 3.Use potentiometer of low Temp.Coefficient or metal film resistor for external VR.
Open the catalog to page 1Warranty We warrant that products contained in this catalog (hereinafter, the “Products”) are free from defects in material and workmanship under normal use for a period of one (1) year from the date of shipment thereof. However, the warranty period for X-ray detectors and X-ray source shall be either one (1) year from the date of shipment or 1,000 hours, whichever shorter.The above warranty shall not apply to any Product which, at our sole judgment, has been:i)Repaired or altered by persons unauthorized by us; or ii)Connected, installed, adjusted or used otherwise than in accordance with...
Open the catalog to page 2All Matsusada catalogs and technical brochures
-
W series
3 Pages
-
RC series
2 Pages
-
TP series
1 Pages
-
TZ series
2 Pages
-
TF series
1 Pages
-
PZJ series
2 Pages
-
XWR series
2 Pages
-
X series
1 Pages
-
XR series
1 Pages
-
Xg Series
4 Pages
-
AMP series
4 Pages
-
DRA series
5 Pages
-
DOS series
8 Pages
-
VOL Series
12 Pages
-
ECA series
2 Pages
-
KA-R series
3 Pages
-
EJC series
2 Pages
-
TA/TC Series
2 Pages