Ultra-compact PCB Mountable cMc Matsusada Prcision Miniature HV Power Supplies TA Sries TC S驩ries 1 kV to 2kV 1.5W 1031-01Pa-1 ■ FEATURES Ultra-compact, PCB mountable Օ Low ripple, 5mVp-p(1kV output type) Low Noise due to metal shielding Օ Well-regulated, high performance External potentiometer or external control voltage programming Օ Arc and continuous short circuit protection NRTL(UL1950), TՙV, CE approved TA and TC Series are miniaturized, well regulated high voltage power supplies suitable for photomultiplier. They feature exceptionally low noise, external potentiometer or voltage control and fully protection against arc and continuous output short circuit. Output voltage (kVdc) Output current (mA)* Model(*Specify "12" for 12Vdc, "15" for 15Vdc input.) Ripple (mVp-p) Positive polar output Negative polar output 0 to 1 1.5 TA-1P-* TC-1P-* TA-1N-* TC-1N-* 5 0 to 1.5 1 TA-1.5P-* TC-1.5P-* TA-1.5N-* TC-1.5N-* 7 0 to 2 0.7 TA-2P-* TC-2P-* TA-2N-* TC-2N-* 10 ■frOutput voltage range for this output current is 50% to 100% of maximum output voltage. ■frOutput current must be derated linearly when operating at levels below 50% of the output voltage capability. SPECIFICATIONS ■ OPTION LS : remote HV ON/OFF Enable to HV ON/OFF with contact signal. When open collector, ON 0.3V(Low) OFF 2V(High) Add LS to the model number. i.e. : TA-1P-12LS, TC-1.5N-15LS Input voltage/current Output control Regulation + 12Vdc ±1Vdc 230mA Typ + 15Vdc ±1Vdc 180mA Typ By external 5k2 potentiometer or external control voltage(Vcon-in) 0 to 6Vdc(Input impedance 0 ^ 30kã2) Line : ±0.02% of max voltage for Vin ±1V Stability Load : 0.02% of max voltage for full load change 0.02%/Hr 0.05%/8Hr Temperature coefficient 0.007%/°C Protection Temperature range rc and continuous output short circuit : -10°C to +50°C Storage : -25°C to +85°C Weight 60g approx Note : Specifications are at the maximum rated output after %Hr warm-up. Օ Specifications are subject to change without notice. ■ DIMENSIONS mm TA k_440_ _^ 16.0 ?| TC ^7-0.6° J2 =4MIN 01 BOTTOM VIEW BOTTOM VIEW 0®®®® ® ® 5.08±0.1 <3* <3> 7.6±0.37.6±0.2 5.08±0.3 35.5 2 x CASE PIN 40.6±0.3 50.8

TA Sries TC Sries 1kV to 2kV 1.5W 1031-01Pa-2 TA Vin CD HV output TC +12Vdc ±1Vdc or +15Vdc ±1Vdc Vin HV output +12Vdc ±1Vdc or +15Vdc ±1Vdc Vcon-in 7J7" ^ -®- CASE PIN 驏LOAD Vcon-in 0 to 6Vdc D -or- VR 5kQ" R1 CASE LOAD 0 to 6Vdc VR -or- R2 R2 - Vref 6.2V HV-GND. - Vref 6.2V HV-GND. (OPTION)LS ^ 0 °~ Short : HV ON Open : HV OFF 1. PIN @ , © are internally connected (isolated from CASE). 2. CASE PIN should be always connected to ground. 3. Input impedance of Pin ® is greater than 30kI2 4. External potentiometer of T.C Ģ 100ppm/°C, PC ( VaW is recommended. (OPTION)LS ^ 0 °~ Short : HV ON Open...