LP2000 Digital loop & Ipsc tester SPECIFICATIONS ELECTRICAL Supply Voltage: 200 to 260V rms, 50/60Hz Test Current: 24A, rms, for two half cycles at 240V Loop Range: 0 to 15Ω nominal in steps of 0.01Ω 15 to 199.9Ω in steps of 0.1Ω Accuracy: ±2% of reading, ±2 digit Temperature Coefficient: ±0.1% / °C Ipsc Range: 0 to 19.99kA in steps of 0.01kA Fuse: 5A, HBC, Anti-Surge ceramic, DIN 5 X 20mm Transient Protection: VDR at input Thermal Protection: Electronic delay Safety: EMC: To BS EN 50081-1, BS EN 50082-1 LVD: To BS EN 61010-1 The model LP2000 Digital Loop Tester is a hand-held, mains Installation Category: Category III powered instrument designed to measure the loop and prospective short circuit current (Ipsc) of electrical circuits in accordance with the 16th Edition of the IEE wiring regulations (BS7671). It has a 3½ digit liquid crystal display. Instrument Housing: 54 X 190 X 90mm approx. The loop is measured over two ranges to 199.9Ω with auto range at 15Ω and with resolutions of 0.01 and 0.1Ω. The Ipsc is measured over one range of 19.99 kA with a Weight: 0.4kg (Less Carry Case) Display: Custom Liquid Crystal Three measurement modes, selected by the function Socket: 4mm Shrouded Mains CEE22 (IEC320) switch, enable loop measurements to be made between Leads: Mains lead with moulded plug(13A fuse). Wander Earth Lead with fused retractable probe and 4mm safety plug. the phase and earth conductor in the mains lead and prospective short circuit current measurements between the phase and neutral conductors in the mains lead. A reading is initiated and displayed when the test button is depressed. The lamps indicate the status of the phase neutral and phase earth conductors and can be interpreted to determine the absence of a conductor or the reversal of two conductors. Storage Temperature: -20°C to +70°C Operating Humidity: 90% RH max at +40°C Due to policy of continuous development, Martindale Electric reserves the right to alter equipment specification and description outlined in this document without prior notice. No part of this document shall be deemed to be part of any contract for the equipment unless specifically referred to as an inclusion within such contract. © Martindale Electric Co. Ltd. 2005 Martindale Electric Company Ltd. Metrohm House, Penfold Trading Estate, Imperial Way, Watford, WD24 4YY. Tel: 01923 441717 Fax: 01923 446900 E-mail: [email protected] Web site: http://www.martindale-electric.co.uk