2. PRODUCT SPECIFIC SAFETY INFORMATION Safety: Complies with BS EN 61010 and BS EN 61557. Overvoltage Category: CAT III 600V, Pollution Degree 2. MARTINDALE ELECTRIC Specification IN2101 & IN2102 Insulation Tester This tester has been designed with your safety in mind, however, no design can completely protect against incorrect use. G Do not touch exposed wiring, connections or other live parts of an electrical circuit. G When using this tester to monitor high voltages, turn off the power before connecting the tester. G If in doubt check the circuit first before touching it. G Do not use cracked or broken test leads. G Do not use in wet conditions. Note: Capacitance Discharge On completion of an insulation test, the tester should remain connected to the circuit under test for a short period after releasing the TEST button. The TEST button if latched must be released. This discharges any capacitance via the tester. Before disconnecting the tester ensure indicated voltage is zero. WARNING THIS TESTER SHOULD ONLY BE USED BY A COMPETENT AND SUITABLY TRAINED PERSON. REMEMBER - SAFETY IS NO ACCIDENT! Warning Before use check the unit for cracks or any other damage. Make sure the unit is free from dust, grease and moisture. Also check any associated leads and accessories for damage. Do not use if damaged. 3 General: Digital Display: 5000 count Overrange: OL is displayed Analogue Bargraph: 51 segment Low battery indication: the symbol is displayed when the battery voltage drops below the operating level. Measurement rate: 2.5 times per second, nominal. Backlight Auto Zero & Autohold Auto Power Off: 5 minutes APO (Auto Power Off) disable option

Safety: Complies with BS EN 61010 and BS EN 61557 (16th Edition) Overvoltage Category: CAT III 600V, Pollution Degree 2. Altitude: Up to 2000M Protection: IP44 Not for use in wet conditions. Operating Environment: 0°C to 40°C at < 70% relative humidity Storage Temperature: -20°C to 60°C, 0 to 80% R.H. with batteries removed from tester. Dimensions: 90 x 210 x 54mm AUTO HOLD Voltage test Voltage warning: >30V Continuity test Short circuit current:>200mA Auto-Discharge: when TEST button released 1. VΩ - Input Terminal This is the positive terminal for voltage and resistance measurements. Connection...

1. INTRODUCTION This manual contains information and warnings which must be followed to ensure safe operation of the IN2101/2. WARNING READ "SAFETY INFORMATION" BEFORE USING THIS METER Auto-Discharge: when TEST button released Insulation test (IN2101) 1.1 Inspection Examine the shipping carton for any sign of damage. Inspect the unit and any accessories for damage. If there is any damage then consult your distributor immediately. You should have the following items: 1. IN2101 or IN2102 2. TL47A lead set 3. Instruction manual 4. Protective carry case with strap 5. Six LR6 alkaline batteries 6....