Specification TEK402 / TEK404 Continuity Tester Specification TEK402 / TEK404 Continuity Tester GENERAL Temperature & Humidity Operating: -10 to 40°C at max 70% R.H Storage: -10°C to 50°C ≤ 80% R.H Altitude: up to 2000m Power: 9V, MN1604/PP3 alkaline battery Dimensions: 150 (H) x 64 (W) x 31 (D) mm Weight: TEK402 Mk3 264g approx (including leads, croc clips & battery) TEK404 Mk2 296g approx (including leads, croc clips & battery) Includes: TL49B test leads with uninsulated crocodile clips (TEK402 only), TL47C test leads with insulated crocodile clips (TEK404 only), 9V battery, instructions. ELECTRICAL TEK402 Mk3 Test voltage: 9V DC (approx) Test current: 11mA (approx, into short circuit) Continuity range (audible): Up to 10kΩ nominal Audible output level: 85dB minimum at 30cm with leads shorted Overvoltage protection fuse rating: 50mA, 250V, Fast Acting Ceramic Fuse, 20mm x 5mm TEK404 Mk2 Test voltage: 9V DC (approx) Test current: < 50μA (into short circuit) Continuity range: 0Ω to 2.2kΩ approx (buzzer loudness and LED brightness reduce with increasing continuity resistance) Audible output level: 85dB minimum at 30cm with leads shorted LED indication: Bright orange LED Alarm function threshold: 30V ± 20V DC or AC rms Check out what else you can get from Martindale: G 17th Edition Testers G Motor Maintenance Equipment G Non-trip Loop Testers G Phase Rotation Testers G Full Calibration & Repair Service G Digital Clamp Meters G Specialist Metrohm Testers (4 & 5kV) G Microwave Leakage Detectors G Specialist Drummond Testers Martindale Electric Company Limited Metrohm House, Penfold Trading Estate, Imperial Way, Watford WD24 4YY, UK Tel: +44(0)1923 441717 Fax: +44 (0)1923 446900 E-mail: [email protected] Website: www.martindale-electric.co.uk © 2012 Martindale Electric Company Ltd. Registered in England No. 3387451. E. & O.E. Document Rev1 LIT400 Rev 6 Safety: TEK402 Mk3 conforms to BS EN61010-1 max 50V to earth TEK404 Mk2 conforms to BS EN61010-1 CAT III 600V Class II Double Insulation Pollution Degree: 2 Test leads supplied conform to BS EN61010-031 CAT III 1000V, 10A EMC: Conforms to BS EN61326