TECHNICAL DATA SHEET Martin® Return Roller Guard The Martin® Return Roller Guard is designed to prevent a worker from being drawn into a return roller. Martin® Return Roller Guards are an economical way to improve safety awareness and reduce worker injuries. The guards should be installed on return rollers that are less than 7 ft high or within reach of workers. For return rollers that are higher than 7 ft and out of reach of workers Martin® Return Roller Baskets can be used. The combination of guards and baskets provides a systematic approach to conveyor guarding that is easy to use and safety compliant. BENEFITS Improves Safety NOMENCLATURE P/N Prefix CEMA Series of Roller Belt Width (inches) Stringer Color/Material Solid upper portion of panel provides pinch point protection while the slotted lower portion allows for inspection while keeping workers protected from rolls. Simple Installation Brackets are included to mount basket directly to either the side or bottom of the stringer. Universal Design Guards are designed to fit all major roll manufacturers’ sizes (CEMA C, D, & E). CEMA SERIES OF ROLLER D: CEMA Series D E: CEMA Series E Easy Access Quick-release pins allow easy access; side and bottom panels swing open for cleanout or maintenance. Removable end plates provide access to roller bearings. COLOR/MATERIAL O: Martin® Orange C: 304 Stainless Steel S: 316 Stainless Steel S: Standard Base W: Wide Base APPLICATION NOTES RRGD-XXXX assemblies will fit all CEMA C or D 4”, 5” & 6” return rollers with 4-1/2” drop brackets only. RRGD-XXXX is available in standard and wide base belt widths 18” thru 72”. RRGE-XXXX assemblies will fit all CEMA E 6” & 7” return rollers with 7” drop brackets only. RRGE-XXXX is available in standard and wide base belt widths 36” thru 96”. Martin Engineering USA One Martin Place Neponset, IL 61345-9766 USA 800 544 2947 or 309 852 2384 Fax 800 814 1553 www.martin-eng.com Form No. L8888-88/11 L3914-08/12 Form No. © Martin Engineering Company 1944, 2011 2012 © Martin Engineering Company