Type 5000 P/I Transducers Description The Type 5000 series is a compact, rugged and reliable family of two-wire pressure transmitters designed for industrial eld service. These instruments convert a signal pressure input into a precise 4-20 or 10-50mA output. The lightweight transmitter housing includes a 1/4 NPT pressure port and a 1/2 NPT conduit port for eld wiring. Connections are easily accessible simply by removing the top cover. Zero and span adjustments are available within the eld wiring compartment for ne, on-site calibration adjustment. Features • 0.1% accuracy typical • Piezo resistive pressure sensor resists vibration • Mounts at any angle • Easily accessible zero and span adjustments • NEMA 4X housing approved for explosion proof service The Type 5000 uses a unique, temperature compensated piezo resistive sensor suitable for gauge pressure measurement of non-corrosive liquids and gases. The sensor has excellent dynamic response and is virtually insensitive to mounting orientation and ordinary industrial vibration. Mounting holes on the transmitter housing are arranged to permit direct pipe (2") mounting for minimum installed cost. Type 5000 Functional Diagram TYPE 5000: Max Load Resistance VS. Supply Voltage 4–20 mA Output: RI = 50 ohms / volt 10–50 mA Output: RI = 20 ohms / volt Agency Approval Notes Factory Mutual T-5000 P/I Transducers NEMA 4X Explosion Proof: Class I, Division 1, Groups B, C, & D, T6 Dust-Ignition Proof: Classes II & III, Division 1, Groups E, F, & G, T6, Type 4X NEMA 4X LOAD RESISTANCE (RI) OHMS Canadian Standards Association T-5000 P/I Transducers Hazardous Locations: Class I, Groups B, C & D; Class II, Group E, F & G; Class III; Encl 4 NEMA 4: P/I transmitter, rated output 4-20mA dc or 10-50mA dc, power supply 30V dc max. The Bellofram T-5000 Transducers were tested and found to comply with Electromagnetic Compatibility Directive effective January 1, 1996. The relevant EMC specications tested were the following: EN 50081-1 (1992) and EN 50082-1 (1992). A Technical Construction File, Serial #107 was written and Certicate of Conformity issued by a Competent Body SUPPLY VOLTAGE (VS) VOLTS

Input signal Output Signal Output Protections Accuracy includes nonlinearity, hysteresis and non-repeatability Overpressure Allowable Loads Response Time Temperature Range-Operating Temperature Effect RFI Effect Power Supply Power Supply Effect Calibration Adjustments In-Process Output Monitoring Connections Mounting Finish Weight Type 5000 Ordering Information 0–15 PSIG 0–1.0 BAR 3–15 PSIG 0.2–1.0 BAR 3–27 PSIG 0.2–1.9 BAR 6–30 PSIG 0.4–2.1 BAR 0.2–1.0 BAR 3–15 PSIG 0–100 PSIG 0–6.9 BAR 4–20 mA DC, 2 wire 10–50 mA DC, 2 wire Reverse polarity protected ± 0.1% span typical; ± 0.25% span max. 45...