FOOT VALVES Cast iron Foot Valve VITON/cast iron trim PN16 Main characteristics • Manufactured in Italy • Flanged according to EN 1092-2 PN16 with raised face undrilled, PN10 or other specifications on request • Vertical installation (flow upwards) • Minimal pressure drop • Hydrostatically tested according to EN 12266-1: Test type P11-12 • Pressure Equipment Directive 2014/68/UE Group 1 • Zinc-plated carbon steel Sieve (special perforations and other material available on request) • Foot valves are usually installed and positioned below the water level, at the lowest point of the intake (suction) piping Corrosion protection • Fuel • Diesel • Lubricating • Standard version: integrally coated with Phenolic-oil resin with zinc-phosphate high corrosion resistance painting Grey Ral 7011 • On request: integrally epoxy coated • Customized color available Hydrostatically tested according to EN 12266-1 (bar) Working temperature (°C) Max Working pressure (bar) P12 Seat Test water 18 Parts Sieve Gasket Nut Screw Seat disc Body Slide bar Obturator Gasket Washer DN 40-DN 150 Washer DN 200-DN 300 Material Zinc-plated carbon steel Viton Zinc-plated 8.8 carbon steel Zinc-plated 8.8 carbon steel EN-GJL-250 grey cast iron EN-GJL-250 grey cast iron CW614N Drawn brass EN-GJL-250 grey cast iron Fiber reinforced Viton Rubber Zinc-plated 8.8 carbon steel EN-GJL-250 grey cast iron EN_180viton - Edition 02/2020 • Maran e Peracini srl assumes no responsibility or liability for typographical errors or omissions and reserves the right to change without notice. MARAN E PERACINI srl Via Valduggia, 25 13011 Borgosesia (VC) - Italy Technical data