TORQUE & SPEED CONDITIONERS DESCRIPTION The TSC Series is the Torque & Speed Conditioner used to connect Magtrol Eddy-Current (WB Series) or Powder (PB Series) Dynamometers to the DSP 7000 Controller. Powered by the DSP 7000, and based on a precision instrumentation amplifier, the unit amplifies and filters the torque signal. It also provides power supply and connections for the speed pickup sensor which is located in the dynamometer. Fig. 1: TSC Series Torque / Speed conditionner with its dedicated cable for connection SYSTEM CONFIGURATION DSP 7000 Dynamometer Controller TORQUE TS / TM / TF Series Torque Sensor TSC Series Torque & Speed Conditioner DES Series Power Supply Computer with M-TEST Software USER DISPLAY DYNAMOMETER CONTROLLER TORQUE UNITS RESET TARE POWER UNITS TORQUE & SPEED CONDITIONER OPEN LOOP BRAKE ON/OFF BRAKE STATUS DISPLAY BOTH SPECIFICATIONS RATINGS Offset ± 0.2 % (Full Scale Defection) ± 0.1 % (Full Scale Defection) Bandwidth (3 dB single pole) Offset Drift Sensitivity Drift ELECTRICAL CHARACTERISTICS Supply Voltage Supply Current a) Torque O/P Voltage b) a) With a 350 Ω load cell bridge and no O/P load b) Rated dynamometer torque © 2023 MAGTROL | Due to continual product development, Magtrol reserves the right to modify specifications without forewarning.

Connector for Dynamometer WB/PB 2.7 & WB/PB 43 (cable to be ordered separately) Torque Signal Speed Signal TORQUE & SPEED CONDITIONER Connector for Dynamometer WB/PB 65, 115 & 15 CABLE ASSEMBLIES Cable to connect the TSC Series to DSP 7000 High-Speed Programmable Dynamometer Controller. Since 2020, Magtrol initiated an upgrade of its device connectivity. 14-pin / Ribbon Connector Depending on the DSP 7000 model, the connectors may not be compatible; for more information please contact our sales department. ORDERING NUMBER 372 : For connection with DSP 700X 368 : For connection with DSP 701X 0500...