Closed Mold Division VenilS Hypaject Mklll Injection Manufacturing • Research & Development • Training • Consultation
Open the catalog to page 1Using the pressure pot principle, pre-mixed resin systems are drawn into the Hypaject MkIII under vacuum, are actively degassed, then dispensed under pressure into the mold cavity. This heated system was developed for the processing requirements of single part epoxy materials, complete with higher levels of control and monitoring. General Specifications: · 6 Litre frame mounted homogeniser with 2 removable seals · Frame mounted control cabinet · Venturi vacuum load/degas system · Regulated pressure inject system · Actuated load valve · Actuated injection valve · 3/8” load and injection pipe ·...
Open the catalog to page 21 Page
2 Pages
1 Page
1 Page
2 Pages
1 Page
3 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
1 Page
3 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages
2 Pages