
LEVEL MEASUREMENT SOLUTIONS • Storage tanks • Process vessels • High or low level alarm • Overflow protection • Explosion-proof installations • Seal pots The Model TK1 liquid level switches are float-actuated devices designed for horizontal mounting in a tank or process vessel through threaded or flanged connections. This low-cost switch is ideal for OEM applications where a single point high or low level alarm is desired. The TK1 achieves switching action through the use of a magnet attached to the float assembly and the magnet’s interaction with a reed switch. As the liquid level changes, the float and, therefore, the float magnet, moves. The proximity of the float magnet to the reed switch causes the switch to change state, making or breaking an electrical circuit. • Process temperature ratings to +300 °F (149 °C) • Compact design • For use on rising or falling level • Reliable reed switch action • All stainless steel construction
Open the catalog to page 1TK1 with threaded connection and SPST or SPDT switch with flying leads TK1 with flanged connection and SPST or SPDT switch with flying leads © Add 0.75" for models with extended stems © Travel below center line is 1.44" for models with extended stems Junction box supplied with DPDT relay Junction box available with SPST or SPDT reed switch 2
Open the catalog to page 2MODEL NUMBER Side-mounted float level switch Narrow Differential, minimum s.g. 0.40, 316/316L stainless steel; maximum process pressure 1500 psi ➀ Use for 11⁄2" nozzles to 0.71" long and 2" nozzles to 1.94" long ➁ Use for 11⁄2" nozzles between 0.72" and 1.25" long PROCESS CONNECTION SIZE 1 1.5" (process connection type code N & T only) PROCESS CONNECTION TYPE AND RATING N BSP-T tapered thread 150# ANSI RF flange (process connection size code 2 only) 300# ANSI RF flange (process connection size code 2 only) SPST reed switch SPDT reed switch Four-wire DPDT powered relay in junction box ➂ 42 VA,...
Open the catalog to page 3WARRANTY All AMETEK LMS Model TK1 liquid level switches are warranted free of defects in materials or workmanship for one full year from the date of original factory shipment. If returned within the warranty period; and, upon factory inspection of the control, the cause of the claim is determined to be covered under the warranty; then, AMETEK LMS will repair or replace the control at no cost to the purchaser (or owner) other than transportation. AMETEK LMS shall not be liable for misapplication, labor claims, direct or consequential damage or expense arising from the installation or use of equipment....
Open the catalog to page 48 Pages
2 Pages
2 Pages
1 Page
1 Page
1 Page
20 Pages
2 Pages
2 Pages
28 Pages
28 Pages
12 Pages
8 Pages
8 Pages
16 Pages
8 Pages
8 Pages
12 Pages
4 Pages
12 Pages
12 Pages
12 Pages
4 Pages
12 Pages
1 Page
8 Pages
4 Pages
8 Pages
12 Pages
20 Pages
16 Pages
12 Pages
2 Pages
24 Pages
12 Pages
12 Pages
12 Pages
12 Pages
20 Pages
8 Pages
8 Pages
12 Pages
4 Pages
16 Pages
16 Pages
1 Page
1 Page
8 Pages
28 Pages
28 Pages
106 Pages
9 Pages
14 Pages
12 Pages
8 Pages
16 Pages
12 Pages
12 Pages
12 Pages