LE PGX
5Pages

Digital Display Proportional Valve Driver A Division of Lynch Fluid Controls Direct DIN solenoid mount PG9 cable gland connection > Independent adjustments (Incl. ramp up & ramp down) ► 3 digit extra bright seven segment LED display >• Large, easy-to-use adjustments and readout ► Display and adjust actual values (Current & Voltage) ► Wide range of supply voltage ► User selectable input type through menu setup ► Wide ramp time range (0 to 99.5 Sec) ► Simple control with analog input, Locally supplied reference voltage >■ Energy efficient PWM circuit/no heat sink required ► Current sensing maintains output regardless of changes in supply voltage and coil resistance ► Electronic limiting circuit/short circuit proof ► Reverse polarity, Command Input protection > Load can be connected & disconnected live > Mounting: Direct on Solenoid DIN 43650-A/ISO 4400 ► Easy troubleshooting/cable length not an issue Operating voltage: Maximum output current: Input signal: Maximum ramp time: Operating Temperature: Protection Grade: page for additional information) Several Forms Available Note: Customization of functionality and enclosure type are available on request. PART NUMBER SYSTEM Proportional Solenoid Driver, Single, solenoid mount with PG9 cable gland Example: LE PGX Lynch Electronics Single, solenoid mount with PG9 cable gland Proportional Solenoid Driver Contact Us For More Information LEPGX-0212-B Toll Free Local & International Canada USA Online WE RESERVE THE RIGHT TO DISCONTINUE MODELS, OR CHANGE SPECIFICATIONS WITHOUT NOTICE OR INCURRING OBLIGATION

Direct DIN solenoid mount, PG9 cable gland connection A Division of Lynch Fluid Controls Cable Requirements Note 1: An IP rating is dependent on proper installation by the user. Round cable with a diameter range Note 2: Wires have to be rated to Contact Us For More Information Toll Free Local & International 1799 Argentia Road 3940 Olympic Blvd. Mississauga, Ontario L5N 3A2 Erlanger, KY 41018 WE RESERVE THE RIGHT TO DISCONTINUE MODELS, OR CHANGE SPECIFICATIONS WITHOUT NOTICE OR INCURRING OBLIGATION

Direct DIN solenoid mount, PG9 cable gland connection A Division of Lynch Fluid Controls EXTERNAL INPUT SIGNAL CONNECTION POWER SUPPLY POTENTIOMETER CONNECTION POWER SUPPLY RAMP UP & DOWN ONLY OPERATION POWER SUPPLY EXTERNAL INPUT SIGNAL CONNECTION POWER SUPPLY TWO WIRE TRANSMITTER INPUT CONNECTION POWER SUPPLY PLEASE NOTE: For "0 to 5 VDC" & "0 to 10 VDC" command input drivers, it is recommended to use independent negative conductors for power supply and analogue output channel (PLC/PC) to maintain command signal accuracy due to voltage drop on long cable runs. €This product has been...

Direct DIN solenoid mount, PG9 cable gland connection Maximum Current output, 0.2 0 to 3.0 0 [Amps] A Division of Lynch Fluid Controls Minimum Current Output, 0.00 to 2.9S [Amps] : COMMAND DEADBAND, Output disabled if command signal less than deadband, to [%] : DITHER FREQUENCY, Contact Us For More Information Toll Free Local & International WE RESERVE THE RIGHT TO DISCONTINUE MODELS, OR CHANGE SPECIFICATIONS WITHOUT NOTICE OR INCURRING OBLIGATION

Direct DIN solenoid mount, PG9 cable gland connection A Division of Lynch Fluid Controls (NOTE: Prior to setting up parameters, you must select proper Input Signal setting for your system) Available Input Signal options ""Applying improper Input Signal to wrong setting on the Driver may be damaging to Driver Unit and may cause driver to fault to Error Status mode*** 1. At power up, the display will show either the output current signal or the input signal (Default display setting shows the output signal). The decimal point will be flashing. 2. Rotate SELECT to enter the set-up mode 3. When...