LydAirή MG single layer ASHRAE media provide superior strength and stiffness for improved pleating characteristics while also offering excellent filtration and dust-holding performance. Available in efficiencies from 50% Ashrae (Merv 9/F-5) and higher, they are engineered for use in both deep-pleat and mini-pleat applications. > Typical Properties Standard Units Metric Units Test Methods Basis Weight 50 lbs/3000 ft 81 g/mҲ T.A.P.P.I. T-410 A.S.T.M. ֖ D-646 Caliper 8psi 16 mils .41 mm T.A.P.P.I. T-411 Tensile MD 4000 gms/inch 4000 gms/inch T.A.P.P.I. ֖ T-494 CD 1400 gms/inch 1700 gms/inch T.A.P.P.I. T-494 Stiffness, MD 900 mgs 900 mgs T.A.P.P.I. ֖ T-543 LOI 6 % 6 % T.A.P.P.I. T-413 DOP 50 % 50 % MIL-STD-282 A.S.T.M. D2986-91 Resistance 3 mm 30 Pa MIL-STD-282 A.S.T.M. ֖ D2986-91 Water Repellency 12 Inches 305 mm MIL-STD-282 Features/Advantages: High dust holding capacity Longer life Best efficiency/DP relationships Engineered for standard and minipleat Special design for gas turbines and contact with harsh environments Applications: Turbine Air Filtration Paint Spray Booth Compressor Inlet Filtration Replacement for Bag Filter Units Standard HVAC Applications Home Filtration Units > www.lydallfiltration.com Telephone: 603-332-4600 E-Mail: [email protected] All data and statements concerning these products may be considered as being indicative of representative properties and characteristics obtainable. Since industry practices vary, we make no warranty, express or implied, concerning their use, nor do we accept responsibility. Rev. Date: 05/12/2008 size="-2">