e-mail: [email protected] „LUMEL” S.A. ul. Stubicka 1 65-127 Zielona Gora POLAND srii SYSTEM FOR INJECTION MOULDS WITH HEATED CHANNELS Complete set for temperature control in injection moulds with heated channels. System equiped with 1 or up to 8 controllers in one housing (depending on the version). Built-in 15 A SSR output for each control zone (output resolution: 0.1 A). PID control wit autotuning and Fuzzy logic algorithm ensuring a high temperature control accuracy and optimal energy consumption. "Soft start" function enables the mould preheating. Monitoring of the leakage current of heater. Signalling of breaks, short-circuits and inverse polarization of the sensor. Measurement of the heater leakage current and detection of the maximal current exceeding. Measurement of the load current, detection and damage signalling. Emergency work mode after the thermocouple damage with a mean power delivered before the damage with a mean power delivered before the damage or with the output turned off. RS-485 interface with MODBUS protocol (ASCII and RTU modes) for connection with PC, recorders or other Modbus devices. Decreased temperature mode (remote activation with logic input or local activation using the buttons). Relay output to signal the alarm states. Digital interface

srii SYSTEM FOR INJECTION MOULDS WITH HEATED CHANNELS External features Overall dimensions of the housing: Readout field Safety and compatibility requirements Elements of the system SR11-11X1X System Temperature sensors. Fig.1. Completion of the SR11 system with ZP11 connections sets „LUMEL” S.A. ul. Stubicka 1 65-127 Zielona Gora POLAND www.lumel.com.pl

SR11 SYSTEM FOR INJECTION MOULDS WITH HEATED CHANNELS A���������� Lumel-Proces software. V��� �� ��� ������ ����� Indicators of alarm states Indicators informing about displayed parameters Display of measured value Display of set point value, output power or current intensity Indicators of vontroller operating mode Push-buttons to set parameters and the operating mode selection Supply swith Holder to pull the module out Signaling connector Main power-switch For more information about LUMEL’s products please visit our website: www.lumel.com.pl Export department: Tel.: +48 68 45 75 139 / /276/...

SR11 SYSTEM FOR INJECTION MOULDS WITH HEATED CHANNELS O������� System SR11 - X X X X Housing dimensions: housing width 77.5 mm 1 number of controllers: 1 housing width 215 mm 3 number of controllers: 2, 3 housing width 365 mm 6 number of controllers: 4, 5, 6 housing width 465 mm 8 number of controllers: 7, 8 Number of controllers: 1 controller 1 2 controllers 2 3 controllers 3 4 controllers 4 5 controllers 5 6 controllers 6 7 controllers 7 8 controllers 8 RS-485 interface: 0 without RS-485 interface 1 with RS-485 interface Connection for moulds: common connectors for thermocouples and heaters...