Dispense Fluids in A Low Volume, Low Pressure, Precision Spray. • Minimize the Over-Spray • Minimize the Cleanup in the Work Area • Minimize Airborne Droplets of Fluids in the Air • Minimize Labor by Automating Dispensing of Fluids • Minimize the Amount of Fluids Used to Manufacture a Part • Minimize the Cleanup of Parts after Manufacturing is Completed

- A Low Velocity, Low Volume Spray System Dispense Fluids in a Controlled Fine Spray. The MinaMizer is aptly named because it minimizes the amount of air and fluid used in fine spray applications. It is common sense to use equipment sophisticated enough to dispense the least amount of fluid necessary to accomplish the right amount of coverage for a particular application. Using excess fluid accomplishes nothing except increasing material cost, part cleanup cost and machine cleanup cost. The MinaMizer uses precision air and fluid regulators that hold true to their settings to maintain the fluid...

Works! FC400 Electronic Controller Controls the On/Off of the spray. Can be set to stay on as long as material is in contact with the Sensor or operate On/Off in unison with the cycle of a machine. Set at 30 PSI to maintain a low pressure fluid supply. Available in one gallon polycarbonate or one, three and five gallon stainless steel reservoirs. Photoelectric Sensor Fluid Filter Large filter to keep fluid clean going to the Nozzle. Top tube delivers air to the Reservoir. Bottom Tube transfers fluid from the Reservoir through the Console to the Nozzle. Three Way Position Valve When activated...

Complete Nozzle Assemblies MZ2011 Up to 95o Fan, depending on viscosity of lubricant MZ2015 Up to 55o Round Fluid Dispensing Nozzles One Nozzle Assembly that accepts either a round spray pattern tip or fan shaped spray nozzle tip. MZ2015 55 degree Round Nozzle Nozzle Holders Five standard nozzle holders designed to cover most applications where intricate positioning of the nozzle is needed. Nozzle holders are designed to allow maximum manipulation of the spray nozzle. Special nozzle holders can be configured upon request. RIGHT SIDE MinaMizer Console only - Nozzles not shown A 12”rod attached...

MZ9020 - MinaMizer Stand A stable stand, five feet tall to hold the MinaMizer, reservoir and LSP Controller. Convenient for easy operation and easy to move from location to location. Stainless Steel Pressure Pots For use with the bigger jobs. Includes: Pressure Gauge, Filter and 5 feet of Distribution Tubing to MinaMizer The FC400 Controller to activate the MinaMizer The FC400 is used when MinaMizer must go on and off with the cycle of a machine. It can pulsate with cycles or skip cycles. The FC400 Electronic Controller (at left) The ultimate MinaMizer Controller offers three individual controls,...