Compuspray
4Pages

The Spray System that Turns Stock Lubrication into a Science The CompuSpray utilizes LSP PresSpray systems for applying the lubricant in a controlled burst so that just the right amount is used on each job. The coil is lubricated in the heavy duty stainless steel cabinet prior to the stock entering the die. Excess lubricant is prevented from leaving the cabinet thus reducing consumption and contributing to a cleaner work area. Should additional lubricant be needed at a critical station of the die, an additional nozzle can be positioned at the station for secondary lubrication. This is the only piece of lubricating equipment that is needed, whether it be stock lubrication or in die lubrication. Check out the CompuSpray and start cleaning up the shop and saving money today.

A totally enclosed spray cabinet where lubricant is applied to coil stock as it passes through on its way to the die. Brushes at the entrance and the exit contain the lubricant in the box and spread it evenly over the material as it exits the cabinet. Any excess lubricant is drained back to the tank to be reused again. Constructed of heavy gauge stainless steel, built to last a lifetime. Easy to use. All assembly is done at the LSP factory thus saving the end user valuable installation time. Built-In Nozzles Nozzles are installed in fixed positions so that the entire width of the stock is...

*0000*S'/ s : 401 The E-205 Electronic Pulsator* Used to control the operation of the PresSpray. Sensor receives a signal from magnet installed on a moving part of the press and alerts the controller. The controller activates the PresSpray so that it pulsates lubricant on the stock as it passes through the cabinet. ■ Refer to the PresSpray Catalog for specifications. The PresSpray Mounted on a Reservoir Reservoir Modules consist of a Bracketed unit mounted on a Reservoir. The Reservoirs are made from a long chain polyethylene plastic that is chemical and abrasive resistant. The Ejectors...

For the CompuSpray External Guides External Guides are bent at 45°angles. They are made of heavy gauge stainless steel, 3" wide and gusseted for strength. When the cabinet is mounted in close proximity to the feeder these guides allow the stock to automatically thread itself into the cabinet. Guides are available for either front and/or back side of the cabinet. Specify which of the guides are needed. E-155 Level Control for 4 Gal. Res. E-158 Level Control for 8 Gal. Res. E-165 Level Control for 15 or 30 (Metal) Gal. Res. Activates a light when the lubricant level is low. Can also be tied...