THE PERFECT ACCESSORY The LNS SE 880 spindle extension can be used to load and guide bars up to 1600 mm in length, making it the perfect accessory to a short bar feeder. Thanks to the spindle length of the lathe and the additional spindle extension, 3m bars can be loaded and guided in half length. This reduces the number of remnants, extends autonomy and increases productivity. BAR GUIDING The stability of the spindle extension SE 880 and it’s guiding tubes, for the diameter range of 8 to 80 mm, allow the system (hydrodynamic guiding tube) a low-noise and low-vibration guiding of the bar to machine parts with optimal cutting speeds. The guide tube is supplied with a continuous flow of oil. The rotation of the bar creates the hydrodynamic effect which centres and supports the bar. The oil supply is interrupted when the bar exits the SE 880 spindle extension. At the guide exit, an air blower removes the oil residue before the bar enters the spindle. The oil supply and activation of the blower are controlled by the LNS short bar feeder PLC. CHANGING THE GUIDE TUBE Changing is quick and easy. The LNS short bar feeder retraction system, which is supplied as standard, frees up the necessary space around the SE 880 spindle extension to allow the guide tube to be accessed and changed very easily. YOUR ONE-STOP-SHOP FOR MACHINE-TOOL PERIPHERALS

The length of the SE 880 spindle extension is determined by the position and length of the spindle on each type of lathe. This configuration must be determined before an offer can be made or an order confirmed. The use of this extension therefore depends on the configuration of the lathe and its spindle. * Depends on the lathe's configuration, to be confirmed when ordering your one-stop-shop for machine-tool peripherals LNS provides a full range of bar feeders, chip conveyors, coolant management systems and air filtration systems which is second to none on the market. We are known in the industry...