TURBO MS500 FILTERING CHIP CONVEYOR TO 500ΜM ECONOMY PLUS FILTRATION The Turbo MS500 is our most economical chip conveyor incorporating coolant filtration, to 500 microns nominal. The Turbo MS500 handles medium to light chip loads including brass, steel and cast iron. This conveyor is ideal for chips from most casting applications and processes most materials with good chip control. YOUR ONE-STOP-SHOP FOR MACHINE-TOOL PERIPHERALS YOUR ONE-STOP-SHOP FOR MACHINE-TOOL PERIPHERALS LNS provides a full range of bar feeders, chip conveyors, coolant management systems and air filtration systems which is second to none on the market. We are known in the industry for the solid expertise we have gained over several decades in an exceptionally wide range of applications, our excellent customer service and our technical support. This support is ensured by highly qualified technicians who are available at key locations throughout Europe.

YOUR BEST CHOICE FOR: • Mixed materials • Fine chips • Dedicated & ferrous materials • Cast iron and brass SELF CLEANING COOLANT FILTRATION Many of today’s value priced machine tools require filtering conveyors. The Turbo MS500 was designed as a cost effective, low maintenance conveyor to solve this application need. Coolant and chips flow from the machine into the watertight frame of the Turbo MS500. Filter boxes, strategically located along the conveyor load section, allow the coolant to escape into the machine tank providing 500 micron filtration. Brushes attached to the conveyor’s scraper...

MINIMAL COOLANT LOSS = COST-EFFECTIVE, ENVIRONMENTALLY FRIENDLY OPERATION Coolant loss is a common problem caused by conveyor belt carry out and wet chips dropping from the conveyor. Special design considerations were taken into account on the Turbo MS500 to reduce wet chips. The chip discharge area offers a special design to ensure dry chips drop into the chip hopper. An angled shelf provides time for the chips to drain until the next scraper forces more chips onto the shelf, pushing the initial load into the hopper. Less coolant loss and post processing of the chips are the obvious advantage....

Fine chips and coolant from the machine Belt direction All transmissions and shafts are reinforced to increase service life Chips are discharged from the conveyor LNS Europe Route de Frinvillier 2534 Orvin Switzerland Clean cutting fluid returning to the tank The self-cleaning filter boxes filter up to 500 µm