Link Engineering Company www.linkeng.com Brake Functionality Test Stand Model 2636 The Model 2636 Brake Functionality Test Stand is a versatile system that can perform a number of performance and durability tests of automotive brake components. The test stand uses an hydraulic pumping unit for durability testing and an electric brake apply for high pressure (burst) testing. The Model 2636 Brake Functionality Test Stand can also perform tests for piston roll back and piston knock back in automotive brake calipers. The tests are performed by applying fluid pressure to the brake caliper simulating service conditions and measuring movement of the brake piston. Features When the fluid pressure is released, the natural rollback of the piston can be measured. During knock back testing, a force may be applied directly to the piston by a linear actuator in order to stimulate additional piston movement. For more information on the Model 2636 Brake Functionality Test Stand, contact LINK at 734-453-0800 or [email protected]. • • • ProLink Software • • • • 6 LVDTs for linear measurement • • • Stainless steel bench Two Brake Apply Systems 7500 psi maximum pressure for Caliper or Master Cylinder Burst Testing 3 Pressure Transducers: 200, 3000, 7500 psi Fluid Displacement Mechanical Actuator for Slide Force Measurement (1150 N and 4460 N) T-Slot Base for easy fixture setup Generic tooling allows a wide array of test procedures Disclaimer: Information presented in this brochure is for informational purposes only. Link Engineering Company reserves the right to make changes, alterations and substitutions to the machines, components or other information presented in this brochure without prior notice. For the latest information contact Link Engineering Company. Equipment pictured in this brochure may be shown with safety equipment removed or disabled for purposes of illustration. Equipment must never be operated with safety equipment removed or disabled. Single Source for Testing Equipment and Services Across America and Around the World Link Engineering Company +734-453-0800 Asia ● Europe ● North America ● South America www. linkeng.com

Link Engineering Company www.linkeng.com Brake Functionality Test Stand Model 2636 Typical Specifications Fluid Displacement Transducer Type Link Flow Meter Maximum Flow Volume 98 cc Flow Resolution 0.01 cc Minimum Flow 0.2 cc / sec Maximum Flow 160 cc / sec Hydraulic Brake Apply Maximum Pressure 200 Bar Pressure Resolution 0.7 Bar Force / Stroke Apply Systems Maximum Stroke 25 mm Stroke Resolution Stroke Speed Maximum Force 0.05 mm 0.1 – 220 mm / sec 1000 N Force Accuracy 1% (+/- 10N) Force Ramp Rate 5-500 N / sec Channels Pressure 2 Linear travel 4 Spare 4 Fluid Displacement 2 The test bench...