Catalogs >
ADI >
ADUM7704

ADUM7704
22Pages

Catalog excerpts

16-Bit, Isolated, Sigma-Delta Modulator ADuM7704 Data Sheet FEATURES FUNCTIONAL BLOCK DIAGRAM VDD2 DATA ENCODER DATA DECODER 5 MHz to 21 MHz master clock input frequency Offset drift vs. temperature: ±0.25 µV/°C maximum SNR: 82 dB typical 16 bits, no missing codes Full-scale analog input voltage range: ±64 mV ENOB: 13 bits typical IDD1: 10 mA maximum On-board digital isolator Operating temperature range −40°C to +125°C (16-lead SOIC_W) −40°C to +105°C (8-lead SOIC_IC) High isolation common-mode transient immunity: 150 kV/µs minimum, VDD2 = 3.3 V Wide-body SOICs 16-lead SOIC_W 8-lead SOIC_IC with increased creepage Safety and regulatory approvals UL recognition 5700 V rms for 1 minute per UL 1577 CSA Component Acceptance Notice 5A VDE Certificate of Conformity DIN V VDE V 0884-10: VIORM = 1270 VPEAK DIN V VDE V 0884-11: VIORM = 1060 VPEAK (pending) APPLICATIONS Shunt current monitoring AC motor controls Power and solar inverters Wind turbine inverters Analog-to-digital and optoisolator replacement GENERAL DESCRIPTION The ADuM7704 is a high performance, second-order, Σ-Δ modulator that converts an analog input signal into a high speed, single-bit data stream, with on-chip digital isolation based on Analog Devices, Inc., iCoupler® technology. The device operates from a 4.5 V to 20 V power supply range (VDD1) and accepts a pseudo differential input signal of ±50 mV (±64 mV full-scale). The pseudo differential input is ideally suited to shunt voltage monitoring in high voltage applications where galvanic isolation is required. The analog input is continuously sampled by a high performance analog modulator and converted to a ones density digital output stream with a data rate of up to 21 MHz. The original information can be reconstructed with an appropriate sinc3 digital filter to Rev. 0 achieve an 82 dB signal-to-noise ratio (SNR) at 78.1 kSPS with a 256 decimation rate and a 20 MHz master clock. The serial input and output operates from a 5 V or a 3.3 V supply (VDD2). The serial interface is digitally isolated. High speed complementary metal-oxide semiconductor (CMOS) technology, combined with monolithic transformer technology, results in the on-chip isolation providing outstanding performance characteristics, superior to alternatives such as optocoupler devices. The ADuM7704 is available in a 16-lead, wide-body SOIC_W with an operating temperature range of −40°C to +125°C and an 8-lead, wide-body SOIC_IC with an operating temperature range of −40°C to +105°C. Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarks and registered trademarks are the property of their respective owners. One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 ©2020 Analog Devices, Inc. All rights reserved. Tech

Open the catalog to page 1

Data Sheet DIN V VDE V 0884-11 Insulation Characteristics (Pending) 7 REVISION HISTORY 8/2020—Revision 0: Initial Version

Open the catalog to page 2

Data Sheet SPECIFICATIONS Vddi = 4.5 V to 20 V, Vdd2 = 3 V to 5.5 V, Vin+ = -50 mV to +50 mV, Vin- = 0 V, Ta = -40°C to +125°C (16-lead SOIC_W), Ta = -40°C to +105°C (8-lead SOIC_IC), MCLKIN frequency (£mclkin) = 20 MHz, tested with a sinc3 filter, and a 256 decimation rate, unless otherwise noted.

Open the catalog to page 3

1 Defined as the time required from an 80% MCLKIN input level to when the output crosses 0.5 x Vdd2, as outlined in Figure 2. Measured with a ±20 pA load and a 25 pF load capacitance.

Open the catalog to page 4

ADuM7704 PACKAGE CHARACTERISTICS Table 3. 1 The device is considered a 2-terminal device. For the 16-lead SOIC_W, Pin 1 to Pin 8 are shorted together and Pin 9 to Pin 16 are shorted together. For the 8-lead SOIC_IC, Pin 1 to Pin 4 are shorted together and Pin 5 to Pin 8 are shorted together. INSULATION AND SAFETY RELATED SPECIFICATIONS Table 4. Parameter Input to Output Momentary Withstand Voltage Minimum External Air Gap (Clearance)1, 2 Symbol Value Viso 5700 min Unit Test Conditions/Comments V rms 1 minute duration mm Measured from input terminals to output terminals, shortest distance...

Open the catalog to page 5

Data Sheet DIN V VDE V 0884-10 INSULATION CHARACTERISTICS This isolator is suitable for reinforced electrical isolation only within the safety limit data. Maintenance of the safety data is ensured by means of protective circuits. Table 6. Description INSTALLATION CLASSIFICATION PER DIN VDE 0110 For Rated Mains Voltage ≤300 V rms For Rated Mains Voltage ≤450 V rms For Rated Mains Voltage ≤600 V rms CLIMATIC CLASSIFICATION POLLUTION DEGREE (DIN VDE 0110, TABLE 1) MAXIMUM WORKING INSULATION VOLTAGE INPUT TO OUTPUT TEST VOLTAGE, METHOD B1 VIORM × 1.875 = VPR, 100% Production Test, tm = 1...

Open the catalog to page 6

Data Sheet DIN V VDE V 0884-11 INSULATION CHARACTERISTICS (PENDING) This isolator is suitable for reinforced electrical isolation only within the safety limit data. Maintenance of the safety data is ensured by means of protective circuits. Table 7. Description INSTALLATION CLASSIFICATION PER DIN VDE 0110 For Rated Mains Voltage ≤300 V rms For Rated Mains Voltage ≤450 V rms For Rated Mains Voltage ≤600 V rms CLIMATIC CLASSIFICATION POLLUTION DEGREE (DIN VDE 0110, TABLE 1) MAXIMUM WORKING INSULATION VOLTAGE INPUT TO OUTPUT TEST VOLTAGE, METHOD B1 VIORM × 1.875 = VPR, 100% Production Test, tm...

Open the catalog to page 7

Data Sheet Rating -0.3 V to +23 V -0.3 V to +6 V -1 V to +4.3 V -0.5 V to Vdd2 + 0.5 V -0.5 V to Vdd2 + 0.5 V ±10 mA ±10 mA ABSOLUTE MAXIMUM RATINGS Ta = 25°C, unless otherwise noted. All voltages are relative to their respective GNDx. Table 8. Parameter Vddi to GNDi Vdd2 to GND2 Analog Input Voltage to GNDi Digital Input Voltage to GND2 Digital Output Voltage to GND2 Input Current to Any Pin Except Supplies1 Output Current from Any Pin Except Supplies Temperature Operating Range Storage Range Junction Pb-Free, Soldering Reflow 1 Transient currents of up to 100 mA do not cause silicon...

Open the catalog to page 8