Global Leaders in Specialized Lifting Equipment!

TWINLIFT 40 TON STANDARD EQUIPMENT ENGINE: BOOM LIFT CYLINDERS: GM Industrial 4.3L Propane Engine 105HP U.S. EPA Tier 3 CARB Tier 3 EU Stage III Twin cylinders capable of lifting and lowering with a full load. Safety holding valves installed on both cylinders. Spherical bearings ensure constant alignment with the boom. CONTROL SYSTEM: Twin cylinders capable of telescoping the boom in and out with a full load. Safety holding valves are installed on both cylinders. CARL (Computer Assisted Remote Lifting) Control System. Monitors Boom Angle, Boom Extension, Counterweight Extension, Pressure, Counterweight...

DIMENSIONAL DATA

REFERENCE CAPACITY / RANGE DIAGRAM 1. The above chart is for reference purposes only. 2. Never use the above chart for lift planning calculations 3. Lift plan calculations are to be determined solely by the load charts and range diagrams that are issued for the specific serial numbered machine that is to be used for the specific planned lift.

TWINLIFT 40 TON RANGE DIAGRAM NOTE 1. The above chart is for reference purposes only. 2. Never use the above chart for lift planning calculations 3. Lift plan calculations are to be determined solely by the load charts and range diagrams that are issued for the specific serial numbered machine that is to be used for the specific planned lift.

LOAD CHARTS FOR "A" COUNTERWEIGHT FULLY EXTENDED 40 TON LOW PROFILE TWINLIFT LOAD CHART FOR USE WITH LIFTING EVE ONLY STANDARD HON-REMOVABLE "A" COUNTERWEIGHT FULLY RETRACTED BOOM LENGTH (FEET] BOOM LENGTH (FEET) A) FLY SECTION CAPACITIES ARE LIMITED BY ANGLE. DO NOT USE LOAD RADIUS WHEN USING FLY SECTION. &'} RATINGS ABOVE THE BOLD LINE ARE BASED ON THE MACHINE'S HYDRAULIC OR STRUCTURAL STRENGTH AND NOT C) RATINGS BELOW THE BOLD LINE ARE BASED ON 85% OF E) TELESCOPE CYLINDERS MUST BE FULLY RETRACTED AND AGAINST STOPS. F) BOOM LENGTH IS FROM REAR OF BOOM TO CENTER OF LIFT EYE. DO NOT EXTEND OR...

LOAD CHARTS FOR "A", "B", AND "C" COUNTERWEIGHT Specifications are provided in imperial dimensions. All equipment dimensions, designs, specifications, calculations, etc., as described, are subject to change at manufacturer's discretion at any time and without notice. Weights are approximate and may vary. Data herein is for informational purposes only and will not be construed to guarantee suitability of equipment for any particular as performance my vary with conditions encountered. Warranty will apply as written in standard contract form upon purchase of equipment. Capacities are for reference...