MBL110 - 110 ton Mobilift
9Pages

Global Leaders in Specialized Lifting Equipment!

MOBILIFT 110 TON STANDARD EQUIPMENT ENGINE: Cummins Diesel Engine: QSB4.5P 160 hp (116 Kw) intermittent @ 2500 rpm U.S. EPA Tier 3 CARB Tier 3 EU Stage III Torque @ 1500 rpm, 466 ft-lbs (632 N-m) High strength three section telescoping boom with powered first section and manually extended second section. Replaceable wear pads on all sliding sections. BOOM LIFT CYLINDERS: Sundstrand 90 series drive pump Twin cylinders capable of lifting and lowering with a full load. Safety holding valves installed on both cylinders. Spherical bearings ensure constant alignment with the boom. CONTROL SYSTEM:...

DIMENSIONAL DATA

REFERENCE CAPACITY / RANGE DIAGRAM HOOK CAPACITY 1. The above chart is for reference purposes only. 2. Never use the above chart for lift planning calculations 3. Lift plan calculations are to be determined solely by the load charts and range diagrams that are issued for the specific serial numbered machine that is to be used for the specific planned lift.

MOBILIFT 110 TON RANGE DIAGRAM NOTE 1. The above chart is for reference purposes only. 2. Never use the above chart for lift planning calculations 3. Lift plan calculations are to be determined solely by the load charts and range diagrams that are issued for the specific serial numbered machine that is to be used for the specific planned lift.

LOAD CHARTS FOR "A" COUNTERWEIGHT (HOOK BLOCK) LOAD CHARTS FOR "A" AND "B" COUNTERWEIGHT (HOOK BLOCK) 110TON MOBILIFT LOAD CHART MLLC221 FOR USE WITH HOOK BLOCK ONLY H'IEWOIO STANDARD NON-REMOVABLE "A" COUNTERWEIGHT WITH "B" COUNTERWEIGHT ADDED FULLY EXTENDED FULLY RETRACTED BOOM LENGTH (FEET) BOOM LENGTH (FEET) A) FLY SECTION CAPACITIES ARE LIMITED BY ANGLE. DO NOT USE LOAD RADIUS WHEN USING FLY SECTION. B) RATINGS ABOVE THE BOLD LINE ARE BASED ON THE MACHINE'S HYDRAULIC OR STRUCTURAL STRENGTH AND NOT C) RATINGS BELOW THE BOLD LINE ARE BASED ON 85% OF E) TELESCOPE CYLINDER MUST BE FULLY...

LOAD CHARTS FOR "A", "B", AND "C" COUNTERWEIGHT (HOOK BLOCK) LOAD CHARTS FOR "A", "B", "C", AND "D" COUNTERWEIGHT (HOOK BLOCK) 110 TON MOBILIFT LOAD CHART MLLC223 FOR USE WITH HOOK BLOCK ONLY ""°™° STANDARD NON-REMOVABLE "A" COUNTERWEIGHT WITH "B","C","D" COUNTERWEIGHT ADDED FULLY EXTENDED FULLY RETRACTED BOOM LENGTH (FEET) BOOM LENGTH (FEET) A) FLY SECTION CAPACITIES ARE LIMITED BY ANGLE. DO NOT USE LOAD RADIUS WHEN USING FLY SECTION. B) RATINGS ABOVE THE BOLD LINE ARE BASED ON THE MACHINE'S HYDRAULIC OR STRUCTURAL STRENGTH AND NOT C) RATINGS BELOW THE BOLD LINE ARE BASED ON 85% OF E)...

LOAD CHARTS FOR "A", "B", "C", "D", and "E" COUNTERWEIGHT (HOOK BLOCK) Specifications are provided in imperial dimensions. All equipment dimensions, designs, specifications, calculations, etc., as described, are subject to change at manufacturer's discretion at any time and without notice. Weights are approximate and may vary. Data herein is for informational purposes only and will not be construed to guarantee suitability of equipment for any particular as performance my vary with conditions encountered. Warranty will apply as written in standard contract form upon purchase of equipment....

POWER BOOM LIFTING EYE LOAD CHARTS WITH FULL COUNTERWEIGHT (A,B,C,D,E WEIGHTS) The ratings above the bold line are based upon machine's hydraulic or structural Ratings below bold line are based on 85% of tipping. Do not extend or retract counterweight with any load suspended on hook. MAILING ADDRESS: EMAIL: liftit@lift-systems.com