MBL033 - 33 ton Mobilift
8Pages

Global Leaders In Specialized Lifting Equipment!

MOBILIFT 30 TONNE STANDARD EQUIPMENT ENGINE: BOOM TELESCOPE CYLINDER: GM 3.0L, 4 cylinder, 56 Kw (75 hp) propane engine Single cylinder capable of telescoping the boom in and out with a full load. Integral safety holding valve. PUMP: Sundstrand 40 series drive pump CONTROL SYSTEM: High performance hydraulic winch. Integral, full load brake. 122 m of high capacity 15.875 mm wire rope standard. CARL (Computer Assisted Remote Lifting) Control System. Monitors Boom Angle, Boom Extension, Pressure, Counterweight Load Pin. Automatic Shutdown for overload conditions. Large easy to read display...

DIMENSIONAL DATA

REFERENCE CAPACITY / RANGE DIAGRAM 1. The above chart is for reference purposes only. 2. Never use the above chart for lift planning calculations 3. Lift plan calculations are to be determined solely by the load charts and range diagrams that are issued the specific serial numbered machine that is to be used for the specific planned lift.

RANGE DIAGRAM 1. The above chart is for reference purposes only. 2. Never use the above chart for lift planning calculations 3. Lift plan calculations are to be determined solely by the load charts and range diagrams that are issued for the specific serial numbered machine that is to be used for the specific planned lift.

LOAD CHARTS FOR BASE UNIT WITH NO COUNTERWEIGHT Specifications are provided in metric dimensions. All equipment dimensions, designs, specifications, calculations, etc., as described, are subject to change at manufacturer's discretion at any time and without notice. Weights are approximate and may vary. Data herein is for informational purposes only and will not be construed to guarantee suitability of equipment for any particular as performance my vary with conditions encountered. Warranty will apply as written in standard con- tract form upon purchase of equipment. Capacities are for...

LOAD CHARTS FOR BASE UNIT WITH 2 COUNTERWEIGHT SLABS Specifications are provided in metric dimensions. All equipment dimensions, designs, specifications, calculations, etc., as described, are subject to change at manufacturer's discretion at any time and without notice. Weights are approximate and may vary. Data herein is for informational purposes only and will not be construed to guarantee suitability of equipment for any particular as performance my vary with conditions encountered. Warranty will apply as written in standard con- tract form upon purchase of equipment. Capacities are for...

LOAD CHARTS FOR BASE UNIT WITH FULL COUNTERWEIGHT (4 SLABS) 30 TONNE MOBILIFT LOAD CHART FOR USE WITH HOOK BLOCK ONLY STANDARD NON-REMOVABLE "A" COUNTERWEIGHT PLUS (4) COUNTERWEIGHT PLATEST FULLY EXTENDED FULLY RETRACTED BOOM LENGTH (METERS) BOOM LENGTH (METERS) A) FLY SECTION CAPACITIES ARE LIMITED BY ANGLE. DO NOT USE LOAD RADIUS WHEN USING FLY SECTION. B) RATINGS ABOVE THE BOLD LINE ARE BASED ON THE MACHINE'S HYDRAULIC OR STRUCTURAL STRENGTH AND NOT E] TELESCOPE CYLINDER MUST BE FULLY RETRACTED AND AGAINST STOPS. FOR BOOM LENGTHS LESS THAN 13.4M WITH FLY SECTION EXTENDED, THE RATED LOADS...