LEVEL LIFT SYSTEM II For Hydraulic Gantry Systems The 2nd generation Level Lift System is here and even easier to use than its predecessor! Instantly know if your lifting beams are level without the need for tape measures or other operator aids. The Level Lift II can be set up in minutes and used on ANY Hydraulic Gantry System! Contact Lift Systems, or your Independent Lift Systems’ Representative today and see how this low-cost solution can increase the safety of your job AND save you time and money! 1/2” (12.5mm) accuracy in 20’ (6 m) = 1/10° 1” (25mm) accuracy in 40’ (12 m) = 1/10° LED Display with 1/10 of a degree readout Uses (8) “AA” Batteries 100’ molded cords for maximum reach Strong magnetic bases for simple, fast, and secure setup No field adjustments required Waterproof sensors Water resistant display Lightweight - only 27 lbs., including the hard sided shipping case Easy to maintain - components can be replaced in the field in minutes EASY-TO-READ DISPLAY CONVEINIENT SHIPPING CASE LIFT SYSTEMS, INC. OFFICE: 1505 - 7th Street East Moline, IL 61244 MAILING ADDRESS: P.O. Box 906 Moline, IL 61266