PFC Module 150W
1 / 4Pages

MORE THAN LIGHT Version without additional cooling unit Order number: LP PFC150W best. 365807:222.25 Version with additional cooling unit Order number: LP PFC150W kpl. 365807:231.25

Description: The PFC Module 150W supplies power to the lamp drivers „PT VIP 2 AC/380 O1“ from Osram. The PFC Module 150W must only be used in a customer case which ensures compliance with the operating conditions, safety instructions and EMC requirements. Any other use is not intended. If the fuse (F1) is changed, make sure to install a fuse of the same power and interruption rating (see technical specifications / line input) to avoid damage to the module and connected devices and injury of the user. Additional cooling unit (only with 365807:231.25 / longer cooling fins available on...

Cooling: Forced cooling required (min. 1 m/s; air flows through the fins of the cooling unit), in versions without additional cooling unit, an external heat sink (e.g., a cooling unit) should be installed at the mounting points of the cooling device on the printed circuit board Figure 1[2]; the cooling unit on the printed circuit board (Figure 1[2]) is connected to PE. The maximum components temperatures in Figure 1 must not be exceeded.