Submersible Hydraulic Elevator Pump Motors Think Experience. The Lincoln Experience Introducing the Submersible Hydraulic Elevator Pump Motors! Our Submersible Hydraulic Elevator Pump Motors are ready to be placed into your elevator systems for applications in Hydraulic pump passenger, service, freight and low rise elevators. Most hydraulic elevators travel up to 6 floors at speeds up to 200 fpm. The motors are designed for the demands in the hydraulic elevator pump industry. We offer this in foot mounted 160ZBS. • Ratings: 15 hp through 50 hp. Totally Open Frame Construction. • 3600 rpm • 3 phase, 60 Hertz • 200 Volts, 230/460 Volts, and later, 575 Volts all suitable for Wye-Delta Starters. • Duty: Intermittent • 1.0SF and Max 70˚C Ambient • Mounting Face: Three bolt circles, 12 mounting holes, and face mounting to accept both the IMO and Allweiler pumps. • 10 feet long leads. Leads are butt spliced at about 48 inches from the motor housing to preventing wicking of hydraulic fluid. Butt splice at 10” or 12” as to attach the long leads. Serving the Elevator Industry Since 1908. Number of power leads is 12 for dual voltage, 230/460 Volts, marked T1 through T12. There are 2 thermostats leads marked P1 and P2. There is 1 green ground lead. • Insulation: Class F • Nameplate: Stainless steel nameplate on motor. A second nameplate shall be supplied for mounting outside of the tank without UL, CSA & CE logos. The nameplate should list the opposite DE bearing AFBMA number. The nameplate states “DUTY INT”. CSA, UL and CE will be required on production units. • “WARNING PLATE” also is provided, mounted on the motor next to the nameplate with a second warning plate for separate mounting. Contact Lincoln Motors for your next Submersible Hydraulic Elevator Pump Motors Opportunity Submersible Hydraulic Elevator Pump Motors