DUAL SEALING A.F.O.® PLUG The Lee Dual Sealing A.F.O. (Axial Force Only) Plug offers a leaktight, metal to metal seal for high pressure applications and also incorporates an O-ring with backup rings for venting or charging. Pressure can be vented out of a side port to remove air from a hydraulic system or safely release trapped high pressure gas. With two backup rings, the Dual Sealing A.F.O. can handle high pressure from either end while in the open position. Machined from materials compliant with NACE specification MR0175, the plug can easily handle a wide range of aggressive wellbore fluids. Dual Sealing A.F.O. Plugs are designed to be both removable and reusable, featuring a unique floating seal that self-aligns to allow for threaded holes that are not perfectly concentric with the thru-hole. Also, the sealing elements resist rotation during installation, which prevents galling of the seat. Incorporating threaded retention, Dual Sealing A.F.O. Plugs only impart axial force on the housing, allowing for minimal wall thickness. For additional information and technical assistance, please visit our website to contact a local Lee Sales Engineer. ■ Seals to 50,000 psi closed ■ Rated to 15,000 psi open ■ Reusable - allows easy access to sealed passageways ■ 400°F temperature rating ■ NACE compliant materials ■ Floating seal self aligns -prevents galling ■ O-ring and backup rings included and installed DUAL SEALING A.F.O. PLUG LEE THE LEE COMPANY 2 Pettipaug Road, PO Box 424, Westbrook, Connecticut 06498-0424 Tel: 860-399-6281 • www.theleeco.com

SEAT COINING Coin the sealing seat using the appropriate tool called out in the table below. The following figures depict a cross section of an installation hole before and after the coining operation. INSTALLATION HOLE BEFORE COINING INSTALLATION HOLE AFTER COINING Coining the seat is accomplished by rotating the coining tool to an appropriate angle. The angle has been calculated to correspond to an even chamfer within the acceptable width. Proper angles of rotation for Lee coining tools are listed in the table to the right. Coining tools are marked with two lines on the top face to aid in the...