Instructions for use CV7-OEM
6Pages

{{requestButtons}}

Catalog excerpts

Instructions for use CV7-OEM - 1

Ultrasonic Wind Sensor LCJ CAPTEURS - ZA le Chêne Ferré 44120 VERTOU – France - Tel 33(0)2 40 05 08 55 lcjcapteurs@lcjcapteurs.com Reg. 42493307500022 / RCS Nantes – VAT : FR17424933075 Page 1 o

Open the catalog to page 1
Instructions for use CV7-OEM - 2

1. Installation Prepare the mast head for the mechanical installation. Use the template for the bracket’s screwing. Align the bracket in order to have the CV7-OEM sensor heading to the bow while the mast is aligned to the boat’s midline. The sensor’s fine alignment will be obtained with the software calibration application. Run the cable down to the display’s interface, avoiding locations where other cables or equipment may produce electromagnetic interferences. Sensor view from below LCJ CAPTEURS - ZA le Chêne Ferré 44120 VERTOU – France - Tel 33(0)2 40 05 08 55 lcjcapteurs@lcjcapteurs.com...

Open the catalog to page 2
Instructions for use CV7-OEM - 3

2. Wind sensor alignment and configuration CV7-OEM is delivered with the following configuration : NMEA0183® Filtering: 2 s Forces of wind unity : Nds Temperature unity: °C Adjustment of the angle of the wind: 0° To choose other parameters, use the downloadable software on this website: www.lcjcapteurs.com. « Configuration_CV7_C ». Realise the following connexions: SubD 9 points Red cable Blue cable Yellow cable Green cable For NMEA 0183 standard input ( RS422) Power supply connections 12V (3 à 30 VDC). Wire Blue - / Wire Red + Red Blue Yellow Green + Power supply 0V + NMEA - NMEA Typical...

Open the catalog to page 3
Instructions for use CV7-OEM - 4

Wind speed range Wind speed resolution Wind speed sensitivity Wind direction range Wind direction resolution Wind direction sensitivity Power requirement Power consumption Boot up delay Dimensions / Sensor Cable Weight / Sensor Operationnal temperature Environement 0.25-40 m/s (0.5 – 80 knots) 0.1 m/s (0.1 knots) 0.13 m/s (0.25 knots) Independent of weather conditions 0-359 ° 1° +/- 1 ° 8 V to 33 V DC 9 mA 4s Cylinder Ø 64 mm - height 61 mm 35 cm standard delivery 4x0.22 mm². 100 gr -15°C to +55°C Sensor IP67 Note: The wind sensors are mounted on an arm of 16 mm diameter by 15 cm length for...

Open the catalog to page 4
Instructions for use CV7-OEM - 5

4. NMEA0183 protocol: Baud rate 4800, data bit 8, parity none, stop bit 1 Flux every 512 milli-second Variable lenght fields, delimiter « , ». Start of sentence : $ End of sentence : CR,LF Voltage outputs: 0 or 5V Symmetrical outputs Examples : $IIMWV,225.0,R,000.0,N,A*38 $WIXDR,C,022.0,C,,*52 $PLCJ,5801,5F01,AA,4253,3341 $PLCJEA870,6D98,C500,0056,AC, Wind angle 000.0° to 359.0° Relative reference Sentence formatter Wind Wind speed Wind speed unit N = knots, M= m/s, K=km/h Sentence formatter Temperature of wind CheckSum Status of CV3F A : available, V=Alarm Temperature Unit of measure C =...

Open the catalog to page 5
Instructions for use CV7-OEM - 6

- Matiere : POM B anc traite anti UV Material: POM White with UV treatment 6. Warranty Your CV7-OEM is warranted against manufacturing defects in materials and workmanship for a period of 2 years from the date of purchase. LCJ Capteurs will at its discretion, repair or replace faulty product free of charge excluding the cost of shipping. Proof of purchase shall be required in order for a warranty claim. All claims shall be made in writing to LCJ Capteurs and once it is accepted by LCJ Capteurs, the faulty product must be sent to LCJ Capteurs address in Vertou, France. For further...

Open the catalog to page 6

All LCJ CAPTEURS catalogs and technical brochures