Instructions for use CV7-E
8Pages

Ultrasonic Wind Sensor LCJ CAPTEURS - ZA le Chêne Ferré 44120 VERTOU – France - Tel 33(0)2 40 05 08 55 lcjcapteurs@lcjcapteurs.com Reg. 42493307500022 / RCS Nantes – VAT : FR17424933075 Page 1 o

1. Installation Prepare the mast head for the mechanical installation. Use the template for the bracket’s screwing. Align the bracket in order to have the CV7-E sensor heading to the bow while the mast is aligned to the North. The sensor’s fine alignment will be obtained with the software calibration application. Run the cable down to the display’s interface, avoiding locations where other cables or equipment may produce electromagnetic interferences. Sensor view from below Bracket mounting template Note :for mounting on vertical surface, the brackets RA106BRACKET and RA106BRACKINOX from...

2. Wind sensor alignment and configuration CV7-E is delivered with the following configuration : NMEA0183® Filtering: 2 s Forces of wind unity : Nds Temperature unity: °C Adjustment of the angle of the wind: 0° To choose other parameters, use the downloadable software on this website: www.lcjcapteurs.com. « Configuration_CV7-C ». Realise the following connexions (only for configuration): SubD 9 points Red cable Blue cable Yellow cable Green cable LCJ CAPTEURS - ZA le Chêne Ferré 44120 VERTOU – France - Tel 33(0)2 40 05 08 55 lcjcapteurs@lcjcapteurs.com Reg. 42493307500022 / RCS Nantes – VAT...

3. Interconnections NMEA 0183 Realise the following connexions: - For RS232 Type PC input Power supply connections 12V (8 a 30 VDC). Wire Blue - / Wire Red + PC SUBD 9 Pts Plug Type COM1 Soldered side - For NMEA 183 standard input ( RS422) Power supply connections 12V (8 a 30 VDC). Wire Blue - / Wire Red + LCJ CAPTEURS - ZA le Chene Ferre 44120 VERTOU - France - Tel 33(0)2 40 05 08 55 lcicapteurs@lcicapteurs.com Reg. 42493307500022 / RCS Nantes - VAT : FR17424933075

4. CV7-E Technical Specifications: Wind speed range Wind speed resolution Wind speed sensitivity Wind direction range Wind direction resolution Wind direction sensitivity Power requirement Power consumption Dimensions / Sensor Boot up delay Cable Arm Cable weight Weight / Sensor + arm and base Weight / Sensor Operational temperature Environement CE Mark 0.25-40 m/s (0.5 – 80 knots) 0.1 m/s (0.1 knots) 0.13 m/s (0.25 knots) Independent of weather conditions 0-359 ° 1° +/- 1 ° 8 V to 33 V DC 9 mA Cylinder Ø 64 mm - height 61 mm 4 seconds 25 m standard delivery 4x0.22 mm². Ø4 mm Aluminium, 300...

5. NMEA0183 protocol: Baud rate 4800, data bit 8, parity none, stop bit 1 Flux every 266 milli-second Variable lenght fields, delimiter « , ». Start of sentence : $ End of sentence : CR,LF Voltage outputs: 0 or 5V Symmetrical outputs Examples : $IIMWV,225.0,R,000.0,N,A*38 $WIXDR,C,022.0,C,,*52 $PLCJ,5801,5F01,AA,4253,3341 $PLCJEA870,6D98,C500,0056,AC, Wind angle 000.0° to 359.0° Relative reference Sentence formatter Wind Wind speed Wind speed unit N = knots, M= m/s, K=km/h CheckSum Status of CV3F A : available, V=Alarm Sentence formatter Temperature of wind Temperature Unit of measure C =...

LCJ CAPTEURS - ZA le Chêne Ferré 44120 VERTOU – France - Tel 33(0)2 40 05 08 55 lcjcapteurs@lcjcapteurs.com Reg. 42493307500022 / RCS Nantes – VAT : FR17424933075 Page 7

7. Warranty Your CV7-Eis warranted against manufacturing defects in materialsand workmanship for a period of 2 years from the date of purchase. LCJ Capteurs will at its discretion, repair or replace faulty product free of charge excludingthe cost of shipping. Proof of purchase shall be required in order for a warranty claim. All claims shall be made in writing to LCJ Capteurs and once it is accepted by LCJ Capteurs, the faulty product must be sent to LCJ Capteurs address in Vertou, France. For further information, please visit www.lcjcapteurs.comwhere video presentations are available. EN...