Laser Mechanisms’ AccuShaper ® 2.0 is a robot end effector that trepans shaped holes of any form at up to four times the speed and twice the accuracy of conventional robot/head combinations – greatly reducing the cycle time of laser hole cutting and trimming operations. The affordable AccuShaper ® 2.0 provides a cutting solution similar to five axis machines at a fraction of the cost. AccuShaper ® 2.0 differs from conventional robot/head combinations in its ability to trepan while imparting minimal reactive forces to the robot producing higher accuracy features. Its patent pending Inertia-Cancelling motion system creates cut features up to 30 mm x 30 mm. Larger features and trim cuts can be trepanned using robot motion throughout its full envelope. The entire package weighs less than 17 kg allowing the use of lower payload, less expensive robots. Features • Patent Pending Inertia-Cancelling motion system for highest speed and accuracy trepanning • Patented high-speed z-axis drive • Capable of both X-Y trepanning and full robot motion envelope trimming Laser Mechanisms’ affordable AccuShaper ® 2.0 provides a cutting solution similar to five axis machines at a fraction of the cost. • Patented capacitive nozzle stand-off sensing • Easily programmed with G-Code or internal shape library • Welding configurations available Specifications Clear Aperture Motion Travel (X-Y-Z axes) Trepanning Speed Path Accuracy Fiber Input Laser Power 4 kW maximum average Specifications subject to change without notice. Laser Mechanisms Europe NV 25325 Regency Drive Novi, Michigan 48375 Phone: (248) 474-9480 Fax: (248) 474-9277 Web: www.lasermech.com E-Mail: [email protected] Laser Mech® and AccuShaper® are registered trademarks of Laser Mech