Incremental rotary encoder IRC340 This encoder is a part of the VALEO motor (only example) and they convert rotary movement onto two electrical signals, each other shifted 90° el. The encoder is used to accurate control of motor speed (or torque if needed) in combination with an electronic control unit. The encoder is adjusted in whole speed range for motor VALEO in both directions. In the development department a similar type of sensor with two or four impulses per rotation is available. With respect to use of electrostatic sensitive components we recommend to connect the encoders without voltage applied and at compliance with rules for handling with electrostatic sensitive devices. Encoder IRC 340 technical specification OUTPUT SIGNALS 2 basic signals (1 and 2) shifted 90° electrical. Sequence of traces at output shaft turning to the right. (Clockwise facing shaft) Changes in technical parameters reserved LARM a.s., Triumf 413, 384 11 Netolice, CR Tel.:+420 388 386 211, Fax:+420 388 386 212, e-mail: [email protected]