Incremental hand wheel IRC530, 535, 536, 537 and 539 The manual incremental hand wheel IRC530, 535, 536, 537 and 539 in standard industrial configuration converts rotary movement, which is manually entered using the hand wheel, by means of photoelectric sensing, to sequence of electric rectangular pulses in the signals A and B (or in their negations) each other shifted of 90° electrical. Solid design with the shaft diameter of 10 mm, with bearings and durable positioning mechanism enables using of this encoder in hard conditions, e.g. as a support hand wheel for CNC machines. The encoder can be supplied with the face panel or without the panel. This encoder can fully replace the encoder IRC505. Assembly The encoders are mounted into an equipment with 3 screws M4 or with a groove. The panel thickness of the equipment must be in range of 0.5 to 6 mm. If the centering diameter 50hi7 is used to hold the encoder, then the panel thickness can be up to 8 mm. With respect to use of electrostatic sensing parts, we recommend to connect the encoder without voltage and complying rules for handling with electrostatic sensitive equipment. Sequence signals by turning right The marked span means locked position for 100 pulses. Data for order State in the order number of pieces, name and type of the encoder, number of pulses per revolution and delivery date. Example: We order 20 pcs of IRC535/100. The encoder IRC 535 with 100 pulses per revolution and delivery in four weeks. Changes in technical parameters reserved