Test Partner™ 4 Data Acquisition Instruments ANALOG CHANNEL SPECIFICATIONS STRAIN/BRIDGE CHANNEL SPECIFICATIONS Sample Rates Analog channels support IEPE-type or voltage-based sensors for performing measurements of acceleration or event detection. The voltage-based event detection Useful Max. Input Voltage provides capabilities to define test constraints for electrical connections and determine when those design constraints have been exceeded. Absolute Max. Input Voltage Data acquisition is provided through analog and/or bridge input channels which support a variety of voltage-based and Wheatstone bridge-type sensors. All channels are over-sampled at 20 MHz with 24-bit ADC providing versatility to acquire dynamic data attributed to drop, shock, impacts, strain, as well as pyro-shock and blast impact events where captured data is rich with high frequency content. Input Impedance IEPE Mode Stimulus Voltage Stimulus Current Output Data Sample Rates 22 VDC 4.5 mA Input Specifications Input Impedance Input Bias Current Absolute Max. Input Voltage Common Mode Input Range Balance Offset Adjust Range Channel Input Warm Up Time Excitation Specifications Excitation Voltage Range Bridge/strain channels support quarter-, half-, or full-bridge and DC-based sensors to measure acceleration, force, strain, pressure, and voltage levels. Excitation Voltage Accuracy Ripple/Noise Output Current Load Regulation Short Circuit Protection Over-Range Protection Timeout An External I/O channel can be configured to trigger or arm the system and an Ethernet interface allows the user to operate TP4 remotely over the network or connected locally to a PC. 0 – 10 V (Excitation + to Excitation -) 0.2% of Full-scale ±2 mV 100 mA ±.05% (10 V, No load - 100 Ω) 390 mA, 200 ms to trip 2 seconds (Excitation to 0 V after timeout) Remote Access to Multiple Tests Multiple workstations can connect and disconnect to a test in process. Users can remotely connect, configure, run, transfer control, and monitor multiple tests. Users can easily access tests on remote units. | 17 Mandeville Cour t, Monterey, California | 93940 | 831.655.6600 | lansmont.com Test Partner 4 (TP4) is our latest generation data acquisition system designed to capture and analyze dynamic events. TP4 incorporates a processing engine to capture substantial amounts of dynamic data as well as an intuitive interface to quickly analyze data parameters. Test Partner Test Partner 4 Data Acquisition

Test Partner 4 Software TP4 software provides the user with an intuitive interface, loaded with powerful features for system setup and recording configurations with a suite of tools for analyzing, managing and reporting of the data. Database file management simplifies processing and retention of large data sets. The software allows the user to configure and interact with single or multiple TP4 systems over the network via commercially available Ethernet hubs and switches. • Intuitive, powerful user interface • Shock analysis • Vibration analysis • Event detection analysis • Strain/force/voltage...