video corpo

Medical Blister Leak and Seal Strength Test
3Pages

{{requestButtons}}

Catalog excerpts

Medical Blister Leak and Seal Strength Test - 1

200 River's Edge Drive, Medford, MA 02155 i-Leaktek 6600 Leak and Seal Strength Tester—Medical Blister Test i-Leaktek 6600 Leak and Seal Strength Tester is designed for determination of seal strength and seal performance test of various heat sealed flexible package and sterilized package, seal performance test of pilfer-proof closures, quantitative testing of leak characteristics, compression resistance, capsule disengaging strength, cap body joint strength, seal-edge seal strength and butting strength of flexible tubes, and testing of anti-compression, seal performance and burst resistance of the Test Procedures A: Power the instrument on and warm up for at least 30 minutes. Prepare the specimen as required. The number of specimens should be not less than 5 and should be free of visible imperfections. Then mount the specimen as shown in the figure below.

Open the catalog to page 1
Medical Blister Leak and Seal Strength Test - 2

200 River's Edge Drive, Medford, MA 02155 B: Set up test parameters and start the test.

Open the catalog to page 2
Medical Blister Leak and Seal Strength Test - 3

200 River's Edge Drive, Medford, MA 02155 C: View test curve and test report. Continue to perform tests by repeating above procedures if necessary. 200 River's Edge Drive

Open the catalog to page 3

All Labthink Instruments Co. catalogs and technical brochures

  1. FDI-01

    5 Pages

  2. DIN 75201

    2 Pages

  3. Torque Meter

    2 Pages

  4. Gas Analyzer

    2 Pages

  5. TOQUE TESTER

    1 Pages

Archived catalogs

  1. Leak Tester

    2 Pages